ZY7007 Datasheet, PDF (26/35 Pages) Power-One – 7A DC-DC Intelligent POL 3V to 14V Input - 0.5V to 5.5V Output

ZY7007 7A DC-DC Intelligent POL Data Sheet
3V to 14V Input • 0.5V to 5.5V Output
directly via the I²C bus by writing into the INT register
shown in Figure 46. Note that the content of the
register can be changed only when the POL is
turned off.
Switching actions of all POLs connected to the SD
line are synchronized to the master clock generated
by the DPM. Each POL is equipped with a PLL and
a frequency divider so they can operate at multiples
(including fractional) of the master clock frequency
as programmed by a user. The POL converters can
operate at 500 kHz, 750 kHz, and 1 MHz. Although
synchronized, switching frequencies of different
POLs are independent of each other. It is
permissible to mix POLs operating at different
frequencies in one system. It allows optimizing
efficiency and transient response of each POL in the
system individually.
R/W-0
FRQ2
Bit 7
R/W-0
FRQ1
R/W-0
FRQ0
R/W-0 ¹⁾ R/W-0 ¹⁾ R/W-0 ¹⁾ R/W-0 ¹⁾ R/W-0 ¹⁾
INT4 INT3 INT2 INT1 INT0
Bit 0
Bit 7:5 FRQ[2:0] : PWM Frequency Selection
000: 500kHz
001: 750kHz
010: 1000lHz
011: 1250kHz
100: 1250kHz
101: 1500kHz
110: 1750kHz
111: 2000kHz
R = Readable bit
W = Writable bit
U = Unimplemented bit,
read as ‘0’
- n = Value at POR reset
Bit 4:0 INT[4:0] : Interleave position
00h: Ton starts with 0.0° Phase lag to SD Line
01h: Ton starts wi th 11.25° Phase lag to SD Line
02h: Ton starts with 22.50° Phase lag to SD Line
…
1Fh: Ton starts with 348.75° Phase lag to SD Line
1) _{Initial value depends on the state of the Interleave Mode ( IM) Input:}
IM=Open: At POR reset the 5 corresponding ADDRESS bits are loaded
IM=Low: At POR reset a 0 is loaded
Figure 46. Interleave Configuration Register INT
8.4.2 Interleave
Interleave is defined as a phase delay between the
synchronizing slope of the master clock on the SD
pin and PWM signal of a POL. The interleave can
be programmed in the GUI PWM Controller window
or directly via the I²C bus by writing into the INT
register.
Every POL generates switching noise. If no
interleave is programmed, all POLs in the system
switch simultaneously and noise reflected to the
input source from all POLs is added together as
shown in Figure 47.
Figure 45. PWM Controller Window
ZD-00245 REV. 2.5
Figure 47. Input Voltage Noise, No Interleave
www.power-one.com
Page 26 of 35