|
TDA8941P Datasheet, PDF (9/21 Pages) NXP Semiconductors – 1.5 W mono Bridge Tied Load BTL audio amplifier | |||
|
◁ |
Philips Semiconductors
TDA8941P
1.5 W mono BTL audio ampliï¬er
102
handbook, halfpage
THD
(%)
10
MGU018
102
handbook, halfpage
THD
(%)
10
MGU019
1
1
(1)
10â1
(2)
10â1
(1)
(2)
10â2
10â2
10â1
1
10
Po (W)
10â2
10â2
10â1
1
10
Po (W)
a. VCC = 9 V; RL = 16 â¦; f = 1 kHz.
b. VCC = 11 V; RL = 25 â¦; f = 1 kHz.
(1) Measured on the standard printed-circuit board without an additional heatsink (see Figure 14). These curves Inï¬uence of
thermal feedback caused by the high power dissipation in combination with the high thermal resistance of the plastic
package.
(2) Measured with a small heatsink on top of the plastic package body; Rth(h-a) = 30 K/W.
Fig 6. Total harmonic distortion as function of output power.
10
handbook, halfpage
THD
(%)
1
10â1
MGU021
(1)
(2)
10
handbook, halfpage
THD
(%)
1
10â1
MGU020
(1)
(2)
10â2
10
102
103
104
105
f (Hz)
10â2
10
102
103
104
105
f (Hz)
a. VCC = 9 V; RL = 16 â¦; Po = 0.1 W.
b. VCC = 9 V; RL = 16 â¦; Po = 0.5 W.
No bandpass ï¬lter applied.
(1) Measured on the standard printed-circuit board without an additional heatsink (see Figure 14). These curves Inï¬uence of
thermal feedback caused by the high power dissipation in combination with the high thermal resistance of the plastic
package.
(2) Measured with a small heatsink on top of the plastic package body; Rth(h-a) = 30 K/W.
Fig 7. Total harmonic distortion as function of frequency.
9397 750 06864
Product speciï¬cation
Rev. 02 â 7 April 2000
© Philips Electronics N.V. 2000. All rights reserved.
9 of 21
|
▷ |