TDA8941P Datasheet, PDF (18/21 Pages) NXP Semiconductors – 1.5 W mono Bridge Tied Load BTL audio amplifier

Philips Semiconductors
TDA8941P
1.5 W mono BTL audio amplifier
18. Revision history
Table 11: Revision history
Rev Date
CPCN Description
02 20000407 -
Product specification; second version; supersedes initial version TDA8941P-01 of
14 April 1999 (9397 750 04876). Modifications:
• Table 1 on page 1:THD: Max value 0.1% changed to → 0.3%;
SVRR: Typ value 65 dB → added
• Ordering options removed
• Section 8 “Functional description”:
– Section 8.1 “Input configuration” on page 3 → added.
– Section 8.2 “Power amplifier” on page 4: ........, capable of delivering a peak output
current of 1.5 A → changed to 2 A.
– Section 8.2.1 “Output power measurement” on page 4 → added
– Section 8.2.2 “Headroom” on page 4 → added
• Section 8.3 “Mode selection”:
– Standby mode: V_MODE > (V_CC − 0.5 V) → changed to (V_CC − 0.5 V) < V_MODE < V_CC; The
power consumption of the TDA8941P will be reduced to <0.18 mW → added.
– Mute mode: the DC level of the input and output pins remain on half the supply
voltage → added;
– 2.5 V < V_MODE < (V_CC − 1.5 V) → changed to 3 V < V_MODE < (V_CC − 1.5 V)
– Section 8.3.1 “Switch-on and switch-off” on page 5 → added.
• Section 8.4 “Supply Voltage Ripple Rejection (SVRR)” on page 5 → added
• Section 8.5 “Built-in protection circuits” on page 6 → added
• Table 5 on page 6:
– P_tot value added 1.25 W
– V_CC(sc) value added 12 V
• Table 7 on page 7: VMODE - mute mode - value Min 2.5 → changed to 3 V
• Table 8 on page 8:
– THD: Max value 0.1% changed to → 0.3%
– SVRR; Typ values 65 and 60 dB → added
– R_source changed to → R_S in table and associated table notes
– Table note [2]: .... 100 mV (RMS).... changed to → ... 700 mV (RMS)....
• Figure 3 to 12: figures added
• Section 13 “Internal circuitry” on page 12: → added
• Figure 13: figure modified
• Section 14.1 “Printed-circuit board (PCB)” on page 13: → added
• Figure 14: figure added
• Section 14.2 “Thermal behaviour and Tamb(max) calculation” on page 15: → added
• Section 15 “Test information” on page 15: Section 15.1 → updated
• Section 15.2 “Test conditions” on page 15: → added.
01 19990414 -
Preliminary specification; initial version.
9397 750 06864
Product specification
Rev. 02 — 7 April 2000
© Philips Electronics N.V. 2000. All rights reserved.
18 of 21