TDA8920C_15 Datasheet, PDF (5/39 Pages) NXP Semiconductors – 2 X 110 W class-D power amplifier

NXP Semiconductors
TDA8920C
2 × 110 W class-D power amplifier
7.2 Pin description
Table 3.
Symbol
VSSA
SGND
VDDA
IN2M
IN2P
MODE
OSC
IN1P
IN1M
n.c.
n.c.
n.c.
PROT
VDDP1
BOOT1
OUT1
VSSP1
STABI
n.c.
VSSP2
OUT2
BOOT2
VDDP2
VSSD
Pin description
Pin
TDA8920CTH TDA8920CJ
1
18
2
19
3
20
4
21
5
22
6
23
7
1
8
2
9
3
10
4
11
5
12
6
13
7
14
8
15
9
16
10
17
11
18
12
19
-
20
13
21
14
22
15
23
16
24
17
Description
negative analog supply voltage
signal ground
positive analog supply voltage
channel 2 negative audio input
channel 2 positive audio input
mode selection input: Standby, Mute or Operating
mode
oscillator frequency adjustment or tracking input
channel 1 positive audio input
channel 1 negative audio input
not connected
not connected
not connected
decoupling capacitor for protection (OCP)
channel 1 positive power supply voltage
channel 1 bootstrap capacitor
channel 1 PWM output
channel 1 negative power supply voltage
decoupling of internal stabilizer for logic supply
not connected
channel 2 negative power supply voltage
channel 2 PWM output
channel 2 bootstrap capacitor
channel 2 positive power supply voltage
negative digital supply voltage
8. Functional description
8.1 General
The TDA8920C is a two-channel audio power amplifier that uses class-D technology.
For each channel, the audio input signal is converted into a digital PWM signal using an
analog input stage and a PWM modulator; see Figure 1. To drive the output power
transistors, the digital PWM signal is fed to a control and handshake block and to high-
and low-side driver circuits. This level-shifts the low-power digital PWM signal from a logic
level to a high-power PWM signal switching between the main supply lines.
A 2nd-order low-pass filter converts the PWM signal to an analog audio signal that can be
used to drive a loudspeaker.
TDA8920C_2
Product data sheet
Rev. 02 — 11 June 2009
© NXP B.V. 2009. All rights reserved.
5 of 39