74HC7046A Datasheet, PDF (33/38 Pages) NXP Semiconductors – Phase-locked-loop with lock detector

Philips Semiconductors
Phase-locked-loop with lock detector
Product specification
74HC/HCT7046A
APPLICATION INFORMATION
Lock-detection circuit
The built-in lock-detection circuit will only work when used
in conjunction with the phase comparator PC2. The
lock-indication is derived from the phase error between
SIG_IN and COMP_IN. The PC2 has a typical phase error of
zero degrees over the entire VCO operating range.
However, to remain in-lock the circuit requires some small
adjustments. The variation is dependent on the loop
parameters and back-lash time (typically 5 ns). Depending
on the application, the phase error can be defined as the
limit, a phase error of greater magnitude would be
considered out-of-lock. An example of an in-lock detection
circuit using the “7046A” is shown in Fig.30.
If the PLL is in-lock, only very small pulses will come from
the “up” or “down” connections of PC2. These pulses are
filtered out by a RC network. A Schmitt trigger produces a
steady state level, a HIGH level indicates an in-lock
condition and a pulsed output indicates an out-of-lock
condition as shown in Fig.31.
See Fig.31 for input waveform.
Fig.30 An example of an in-lock detection circuit using the “7046A”.
(a)
(b)
Fig.31 Waveforms showing the lock detection process; (a) in-lock; (b) out-of-lock.
December 1990
33