PDIUSBD12 Datasheet, PDF (22/35 Pages) NXP Semiconductors – USB interface device with parallel bus

Philips Semiconductors
PDIUSBD12
USB interface device with parallel bus
12. Interrupt modes
Table 11: Interrupt modes
SOF-ONLY INTERRUPT MODE^[1]
0
0
1
INTERRUPT PIN MODE^[2]
0
1
X
Interrupt types
Normal^[3]
Normal + SOF ^[3]
SOF only
[1] Bit 7 of Clock division factor byte of Set mode command (see Table 6).
[2] Bit 5 of Set DMA command (see Table 7).
[3] Normal interrupts from Interrupt Register.
13. Limiting values
Table 12: Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134).
Symbol Parameter
Conditions
Min
V_CC
V_I
I_latchup
V_esd
supply voltage
input voltage
latchup current
electrostatic discharge
voltage
V_I < 0 or V_I > V_CC
I_LI < 1 µA
−0.5
−0.5
−
[1][2] _−
T_stg
storage temperature
−60
P_tot
total power dissipation V_CC = 5.5 V
−
[1] Equivalent to discharging a 100 pF capacitor via a 1.5 kΩ resistor.
[2] Values are given for device only; in-circuit V_esd(max) = ±8000 V.
Max
Unit
+6.0
V
V_CC + 0.5 V
100
mA
±2000 V
+150
°C
95
mW
Table 13: Recommended operating conditions
Symbol Parameter
Conditions
V_CC1
DC supply voltage
(Main mode)
apply V_CC1 to V_CC
pin only
V_CC2
DC supply voltage
(Alternate mode)
apply V_CC2 to both
V_CC and V_out3.3
pins
V_I
V_I/O
V_AI/O
DC input voltage
DC input voltage for I/O
DC input voltage for
analog I/O
V_O
T_amb
DC output voltage
operating ambient
temperature in free air
See Section 14
and Section 15
per device.
Min
Max
Unit
4.0
5.5
V
3.0
3.6
V
0
5.5
V
0
5.5
V
0
3.6
V
0
V_CC
V
−40
+85
°C
9397 750 09238
Product data
Rev. 08 — 20 December 2001
© Koninklijke Philips Electronics N.V. 2001. All rights reserved.
22 of 35