English
Language : 

CAT5409WI-25 Datasheet, PDF (1/16 Pages) ON Semiconductor – Quad Digitally Programmable Potentiometers with 64 Taps and I²C Interface
CAT5409
Quad Digitally Programmable Potentiometers
(DPP™) with 64 Taps and I²C Interface
FEATURES
„ Four linear taper digitally programmable
potentiometers
„ 64 resistor taps per potentiometer
„ End to end resistance 2.5kΩ, 10kΩ, 50kΩ or
100kΩ
„ I²C interface
„ Low wiper resistance, typically 80Ω
„ Four non-volatile wiper settings for each
potentiometer
„ Recall of saved wiper settings at power-up
„ 2.5 to 6.0 volt operation
„ Standby current less than 1µA
„ 1,000,000 nonvolatile WRITE cycles
„ 100 year nonvolatile memory data retention
„ 24-lead SOIC and 24-lead TSSOP
„ Write protection for data register
For Ordering Information details, see page 15.
DESCRIPTION
The CAT5409 is four Digitally Programmable
Potentiometers (DPP™) integrated with control logic
and 16 bytes of NVRAM memory.
A separate 6-bit control register (WCR) independently
controls the wiper tap position for each DPP.
Associated with each wiper control register are four
6-bit non-volatile memory data registers (DR) used for
storing up to four wiper settings. Writing to the wiper
control register or any of the non-volatile data
registers is via a I²C serial bus. On power-up, the
contents of the first data register (DR0) for each of the
four potentiometers is automatically loaded into its
respective wiper control register (WCR).
The Write Protection (¯W¯P¯) pin protects against
inadvertent programming of the data register.
The CAT5409 can be used as a potentiometer or as a
two terminal, variable resistor. It is intended for circuit
level or system level adjustments in a wide variety of
applications.
PIN CONFIGURATION
FUNCTIONAL DIAGRAM
SOIC (W)
TSSOP (Y)
SDA 1
A1 2
RL1 3
RH1 4
RW1 5
GND 6
NC 7
RW2 8
RH2 9
RL2 10
SCL 11
A3 12
24 WP
23 A2
22 RW0
21 RH0
20 RL0
19 VCC
18 NC
17 RL3
16 RH3
15 RW3
14 A0
13 NC
VCC 1
RL0 2
RH0 3
RW0 4
A2 5
WP 6
SDA 7
A1 8
RL1 9
RH1 10
RW1 11
GND 12
24 NC
23 RL3
SCL
SDA
22 RH3
21 RW3
WP
20 A0
A0
A1
19 NC
A2
A3
18 A3
17 SCL
16 RL2
15 RH2
14 RW2
13 NC
RH0
RH1
RH2
RH3
I²C BUS
WIPER CONTROL
INTERFACE
REGISTERS
RW0
RW1
NONVOLATILE
RW2
CONTROL LOGIC
DATA
REGISTERS
RW3
RL0
RL1
RL2
RL3
© 2008 SCILLC. All rights reserved.
1
Characteristics subject to change without notice
Doc. No. MD-2010 Rev. L