K3NC Datasheet, PDF (21/23 Pages) Omron Electronics LLC – Up/Down Counting Meter

Protect Mode
Changing Set Values
By pressing the Shift Key while a parameter is displayed, the set value can be
changed (setting status). The PROG status indicator will flash. Change the set
value as required, and press the Mode Key to register the setting and move to
the next parameter.
Setting Status
count
u-d c
Change the set value using the Up
Key and the Shift Key .
Next parameter
PROG flashes.
If there is no key operation for 5 seconds,
the setting is registered and the parameter
is displayed again.
Prescaling menu
1s
Prescale value
bank
−
(See note 1.) ^{No key operation for 5 s}
Input A prescale
value mantissa
−
−
(See note 1.) ^{No key operation for 5 s}
Input A prescale
value exponent
−
−
No key operation for 5 s
(See note 1.)
Decimal point
−
No key operation for 5 s
Setup menu
1s
Input mode
Sensor type
Communications
unit number
Baud rate
Word bit length
Stop bits
Parity bits
u-d b/u-d c
No key operation for 5 s
No key operation for 5 s
−
No key operation for 5 s
1200/2400/4800/
9600 /19200/38400bps
No key operation for 5 s
7 /8bit
No key operation for 5 s
1/ 2 bit
No key operation for 5 s
/
/
Option menu
1s
Power failure
memory
Compensation
value
Conditions that
allow compensa-
tion input
Output mode
Upper limit (H)
of linear out-
put range
Lower limit (L)
of linear out-
put range
Remote/local
programming
No key operation for 5 s
−₀−
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
−
No key operation for 5 s
−
No key operation for 5 s
/
· In the Setting Mode, the measurement value is reset (i.e., to
0) and outputs turn OFF.
· The measurement value will be reset if the Setting Mode is
entered during measurement.
· Depending on the output type of the model used, some
parameters (indicated in
) are not displayed (and
hence cannot be set).
· If the input mode is changed, all parameters will be reset to
their initial values. Set the input mode first.
Note 1: A number in the range 1 to 4 will be displayed.
Settings displayed in reverse colors are defaults.
Up/Down Counting Meter K3NC C-151