D2U5T-H3-7000-54-HU4C Datasheet, PDF (5/8 Pages) Murata Manufacturing Co., Ltd. – AC-DC Three Phase Power Converter

D2U5T-H3-7000-54-HU4C
AC-DC Three Phase Power Converter
Control Signals
Signal (I/O)
Description
PS_ON_H (Input)
Internal 10K pull-up resistor to internal VDD⁶
• Leaving signal pin open = Main Output ON
• Tying signal pin to GND = Main Output OFF
PS_KILL (Input)
Short pin; internal 10K pull-up resistor to internal VDD⁶
• Leaving signal pin open = All Outputs off
• Tying signal pin to GND = All Outputs enabled
PS_FAULT_L (Output)
PWR_GOOD_H (Output)
Internal 10K pull-up resistor to internal VDD⁶
• PSU Fault Status
Internal 10K pull-up resistor to internal VDD⁶
• Main Output Status OK
I_SHARE (Input/output -bus)
Analog representation of main output current; can be left open if not used
STBY_SEL_IN (Input)
Internal 10K pull-up resistor to internal VDD⁶
• Leaving signal pin open = +5V STBY
• Tying signal pin to GND = 3V3STBY
AC_OK_H (Output)
Internal 10K pull-up resistor to internal VDD⁶
• AC OK Status
SMB_ALERT_L (Output)
Internal 10K pull-up resistor to internal VDD⁶
• SMB Alert signal output
6 VDD depends on Standby Voltage selection of either 3.3V or 5V.
AC POWER CONNECTOR
Header
Positronic PLS5W5F1000
Position
Part Number
1
Positronic: FS612N2
Contacts
2
Positronic: FS612N2
3
-
4
Positronic: FS612N2
5
Positronic: FS612N2
1.795
[45.59]
1
23
4
5
1.295
[32.89]
Function
Safety Ground
AC Line Voltage Ph 1
Not fitted
AC Line Voltage Ph 2
AC Line Voltage Ph 3
0.401
[10.18]
0.802
[20.36]
2X Ø0.100 [Ø2.54] THRU
www.murata-ps.com/support
D2U5T-H3-7000-54-HU4C.A02 Page 5 of 8