PDSP16256 Datasheet, PDF (22/28 Pages) Mitel Networks Corporation – Programmable FIR Filter

PDSP16256
Test
Waveform measurement level
Delay from
VH
output high
0·5V
to output
high impedance
Delay from
output low
to output
high impedance
VL
0·5V
Delay from
1·5V
output high
0·5V
impedance to
output low
Delay from
output high
impedance to
output high
1·5V
0·5V
V_H is the voltage reached when the output is driven high
VL is the voltage reached when the output is driven low
IOL
1·5V
DUT
30pF
IOH
Three state delay measurement load
Figure. 23 Three state delay measurement
Absolute Maximum Ratings (Note 1)
Supply voltage, V_DD
20·5V to 17·0V
Input voltage, V_IN
20·5V to V_DD 10·5V
Output voltage, V_OUT
20·5V to V_DD 10·5V
Clamp diode current per pin, I_K (see note 2)
18mA
Static discharge voltage (HBM)
500V
Storage temperature, T_S
265°C to1150°C
Maximum junction temperature, T_JMAX
Commercial grade
1100°C
Industrial grade
1110°C
Military grade
1150°C
Package power dissipation
3000mW
Thermal resistance, Junction-to-Case, θ_JC
5°C/W
NOTES
1. Exceeding these ratings may cause permanent
damage. Functional operation under these conditions
is not implied.
2. Maximum dissipation should not be exceeded for
more than 1 second, only one output to be tested at
any one time.
3. Exposure to absolute maximum ratings for extended
periods may affect device reliablity.
4. Current is defined as negative into the device.
5. The θ_JC data assumes that heat is extracted from the
top of the package.
6. Maximum junction temperature, T_JMAX, is specified
with power applied.
PDSP16256 MC AC1R and PDSP16256 MC GC1R
(MIL-STD-883 PARTS)
Polyimide is used as an inter-layer dielectric as
glassification. Polymeric material meeting the
requirements of MIL-STD-883 test method 5011 is used
for die attach.
Life tesst/burn-in connections are given in Tables 9 and
10 on the following pages.
Change Notification
The change notification requirements of MIL-PRF-38535
will be implemented on MIL-STD-883 grade devices.
Known customers will be notified of any changes since
the last buy when ordering further parts if significant
changes have been made.
Rev.
A
B
C
D
Date MAR 1993 SEPT 1995 JAN 1998 AUG 1998
22