HAL-APB-V1.5 Datasheet, PDF (10/59 Pages) Micronas – Application Board HAL-APB V1.x

HAL1820, HAL24xy, HAL28xy, HAL36xy, HAL38xy
Application Board HAL-APB V1.x
3. Board Configuration
APPLICATION NOTE
3.1. Jumper Settings
For changing between LIN-Bus and Biphase-M communication, jumpers need to be set
differently. For non-housed (optional) application boards it may be necessary to switch
jumper for USB/RS-232 connection. The following pictures show how to set the jump-
ers correctly.
X4 - RS232
(SUB-D-9)
SW ^X3
JP3
USB
(B)
+18 VDC
X2 
Reset
X4 - RS232
(SUB-D-9)
SW
JP3
JP2
JP5
X3
USB
(B)
Reset
+18 VDC
X2 
Status LEDs
HAL-APB
Version 1.3
Status LEDs
HAL-APB
Version 1.5
HAL1
Status LEDs on housing
RJ-45
HAL1/2
JP4
HAL1
Status LEDs on housing
RJ-45
HAL1/2
Fig. 3–1: Jumper settings HAL-APB V1.x
The default jumper position Pos1 is indicated by black bars in Fig. 3–1.
Note: For board versions higher than v1.3, no manual adjustment is required. The
HAL-APB firmware automatically detects the appropriate protocol to be used for
the Hall sensor.
10
Oct. 8, 2012; APN000055_003EN
Micronas