EQCO30R5.D Datasheet, PDF (5/24 Pages) Microchip Technology – EQCO30R5.D 3G/HD-SDI Video Cable Equalizer

EQCO30R5.D
1.1 Pinout and Pin Description
FIGURE 1-2:
EQCO30R5.D PIN DIAGRAM (VIEWED FROM TOP)
VCC
NC
NC VCC
16
15
14
13
GND 1
12 GND
SDIp 2
11 SDOp
SDIn 3
EQCO30R5
10 SDOn
GND 4
GND TAB
9 GND
5
6
7
8
LFI AmpR NC
NC
TABLE 1-1: EQCO30R5.D PIN DESCRIPTIONS
Pin Number
Pin Name
Signal Type
Description
(TAB)
13, 16
1, 4, 9, 12
2, 3
11, 10
5
6
7
8
14
15
GND
VCC
GND
SDIp, SDIn
Power
Power
Power
CML Input
SDOp/SDOn CML Output
LFI
AmpR
NC
NC
NC
NC
Input
Input
Input
Input
Input
Input
Use as single-point ground.
+3.3V of power supply.
Connect to ground of power supply.
Serial input positive/negative differential serial input. Connect
SDIn to ground reference via termination network. External
75Ω resistors are required.
Serial output positive/negative differential serial output.
Output has a swing of 2x370 mV and has 50Ω on-chip
termination resistors to internal V_DD (1.2V).
Uplink signal. (Low = 0V, High = 1.2V). When driving from
3.3V, an external series resistance of 6.2 kΩ is required.
Connect to ground with a 1 kΩ resistor, defining the uplink
amplitude to 150 mV.
Do not connect. Used for internal testing.
Do not connect. Used for internal testing.
Do not connect. Used for internal testing.
Do not connect. Used for internal testing.
 2011-2016 Microchip Technology Inc.
DS60001304B-page 5