LAN8710A Datasheet, PDF (37/82 Pages) SMSC Corporation – Small Footprint MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR Technology

Small Footprint MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR^® Technology
Datasheet
Table 3.6 MODE[2:0] Bus
DEFAULT REGISTER BIT VALUES
MODE[2:0]
MODE DEFINITIONS
REGISTER 0
REGISTER 4
[13,12,10,8]
000
10Base-T Half Duplex. Auto-negotiation disabled.
001
10Base-T Full Duplex. Auto-negotiation disabled.
010
100Base-TX Half Duplex. Auto-negotiation
disabled.
CRS is active during Transmit & Receive.
011
100Base-TX Full Duplex. Auto-negotiation disabled.
CRS is active during Receive.
100
100Base-TX Half Duplex is advertised. Auto-
negotiation enabled.
CRS is active during Transmit & Receive.
101
Repeater mode. Auto-negotiation enabled.
100Base-TX Half Duplex is advertised.
CRS is active during Receive.
110
Power Down mode. In this mode the transceiver will
wake-up in Power-Down mode. The transceiver
cannot be used when the MODE[2:0] bits are set to
this mode. To exit this mode, the MODE bits in
Register 18.7:5(see Section 4.2.9, "Special Modes
Register," on page 60) must be configured to some
other value and a soft reset must be issued.
111
All capable. Auto-negotiation enabled.
0000
0001
1000
1001
1100
1100
N/A
X10X
[8,7,6,5]
N/A
N/A
N/A
N/A
0100
0100
N/A
1111
The MODE[2:0] hardware configuration pins are multiplexed with other signals as shown in Table 3.7.
Table 3.7 Pin Names for Mode Bits
MODE BIT
MODE[0]
MODE[1]
MODE[2]
PIN NAME
RXD0/MODE0
RXD1/MODE1
COL/CRS_DV/MODE2
3.7.3
RMIISEL: MII/RMII Mode Configuration
MII or RMII mode selection is latched on the rising edge of the internal reset (nRST) based on the
strapping of the RMIISEL configuration strap. The default mode is MII (via the internal pull-down
resistor). To select RMII mode, pull the RMIISEL configuration strap high with an external resistor to
VDDIO.
When the nRST pin is deasserted, the MIIMODE bit of the Special Modes Register is loaded according
to the RMIISEL configuration strap. The mode is reflected in the MIIMODE bit of the Special Modes
Register.
Refer to Section 3.4, "MAC Interface," on page 30 for additional information on MII and RMII modes.
SMSC LAN8710A/LAN8710Ai
37
DATASHEET
Revision 1.4 (08-23-12)