English
Language : 

LAN8710A Datasheet, PDF (14/82 Pages) SMSC Corporation – Small Footprint MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR Technology
Small Footprint MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR® Technology
Datasheet
Table 2.2 LED Pins (continued)
NUM PINS
NAME
SYMBOL
BUFFER
TYPE
DESCRIPTION
LED 2
LED2
nINT/TXER/
nINTSEL
TXD4
Function
Select
1
Configuration
Strap
O12
IS
(PU)
Link Speed LED Indication. This pin is driven
active when the operating speed is 100Mbps. It
is inactive when the operating speed is 10Mbps
or during line isolation.
Note: Refer to Section 3.8.1, "LEDs," on
page 39 for additional LED information.
This configuration strap selects the mode of the
nINT/TXER/TXD4 pin.
„ When nINTSEL is floated or pulled to VDD2A,
nINT is selected for operation on the
nINT/TXER/TXD4 pin (default).
„ When nINTSEL is pulled low to VSS,
TXER/TXD4 is selected for operation on the
nINT/TXER/TXD4 pin.
See Note 2.2 for more information on
configuration straps.
Note:
Refer to See Section 3.8.1.2, "nINTSEL
and LED2 Polarity Selection," on
page 39 for additional information.
Note 2.2
Configuration strap values are latched on power-on reset and system reset. Configuration
straps are identified by an underlined symbol name. Signals that function as configuration
straps must be augmented with an external resistor when connected to a load. Refer to
Section 3.7, "Configuration Straps," on page 36 for additional information.
Table 2.3 Serial Management Interface (SMI) Pins
NUM PINS
1
1
NAME
SMI Data
Input/Output
SMI Clock
SYMBOL
MDIO
MDC
BUFFER
TYPE
DESCRIPTION
VIS/
VOD8
Serial Management Interface data input/output
VIS
Serial Management Interface clock
NUM PINS
1
1
NAME
Ethernet
TX/RX
Positive
Channel 1
Ethernet
TX/RX
Negative
Channel 1
Revision 1.4 (08-23-12)
Table 2.4 Ethernet Pins
SYMBOL
TXP
BUFFER
TYPE
DESCRIPTION
AIO
Transmit/Receive Positive Channel 1
TXN
AIO
Transmit/Receive Negative Channel 1
14
DATASHEET
SMSC LAN8710A/LAN8710Ai