KSZ8081MNX Datasheet, PDF (21/66 Pages) Micrel Semiconductor – 10Base-T/100Base-TX Physical Layer Transceiver

KSZ8081MNX/RNB
3.3.5 TRANSMIT ENABLE (TXEN)
TXEN indicates that the MAC is presenting dibits on TXD[1:0] for transmission. It is asserted synchronously with the first
dibit of the preamble and remains asserted while all dibits to be transmitted are presented on the RMII. It is negated
before the first REF_CLK following the final dibit of a frame.
TXEN transitions synchronously with respect to REF_CLK.
3.3.6 TRANSMIT DATA[1:0] (TXD[1:0])
TXD[1:0] transitions synchronously with respect to REF_CLK. When TXEN is asserted, the PHY accepts TXD[1:0] for
transmission.
TXD[1:0] is 00 to indicate idle when TXEN is de-asserted. The PHY ignores values other than 00 on TXD[1:0] while
TXEN is de-asserted.
3.3.7 CARRIER SENSE/RECEIVE DATA VALID (CRS_DV)
The PHY asserts CRS_DV when the receive medium is non-idle. It is asserted asynchronously when a carrier is
detected. This happens when squelch is passed in 10 Mbps mode, and when two non-contiguous 0s in 10 bits are
detected in 100 Mbps mode. Loss of carrier results in the de-assertion of CRS_DV.
While carrier detection criteria are met, CRS_DV remains asserted continuously from the first recovered dibit of the
frame through the final recovered dibit. It is negated before the first REF_CLK that follows the final dibit. The data on
RXD[1:0] is considered valid after CRS_DV is asserted. However, because the assertion of CRS_DV is asynchronous
relative to REF_CLK, the data on RXD[1:0] is 00 until receive signals are properly decoded.
3.3.8 RECEIVE DATA[1:0] (RXD[1:0])
RXD[1:0] transitions synchronously with respect to REF_CLK. For each clock period in which CRS_DV is asserted,
RXD[1:0] transfers two bits of recovered data from the PHY.
RXD[1:0] is 00 to indicate idle when CRS_DV is de-asserted. The MAC ignores values other than 00 on RXD[1:0] while
CRS_DV is de-asserted.
3.3.9 RECEIVE ERROR (RXER)
RXER is asserted for one or more REF_CLK periods to indicate that a symbol error (for example, a coding error that a
PHY can detect that may otherwise be undetectable by the MAC sub-layer) was detected somewhere in the frame being
transferred from the PHY.
RXER transitions synchronously with respect to REF_CLK. . While CRS_DV is de-asserted, RXER has no effect on the
MAC.
3.3.10 COLLISION DETECTION (COL)
The MAC regenerates the COL signal of the MII from TXEN and CRS_DV.
3.3.11 RMII SIGNAL DIAGRAM
The KSZ8081RNB RMII pin connections to the MAC for 25 MHz clock mode are shown in Figure 3-3. The connections
for 50 MHz clock mode are shown in Figure 3-4.
 2016 Microchip Technology Inc.
DS00002202A-page 21