English
Language : 

MIC3003GFL Datasheet, PDF (72/74 Pages) Micrel Semiconductor – FOM Management IC with Internal Calibration
Micrel, Inc.
MIC3003GFL
Calibration Constants (CALCOEFn)
Default values
Serial address
Byte addresses
Offset coefficients are set to a default value of zero
Slope coefficients are set to a default value of 1.0
A6h
74 - 87 = 4Ah - 57h
These registers hold the slope and offset coefficients used to calibrate the MIC3003’s ADC results in internal calibration mode.
Note that the temperature offset is also used in external calibration mode; but this can be disabled in OEMCFG5 (or by setting
the offset coefficient to zero).
These registers are non-volatile and will be maintained through power and reset cycles. A valid OEM password is required for
access to these registers.
A6
Address
74 (4Ah)
75 (4Bh)
76 (4Ch)
77 (4Dh)
78 (4Eh)
79 (4Fh)
80 (50h)
81 (51h)
82 (52h)
83 (53h)
84 (54h)
85 (55h)
86 (56h)
87 (57h)
Bytes
Definition
TOFFh
TOFF0l
VSLP0h
VSLP0l
VOFFh
VOFF0l
ISLP0h
ISLP0l
IOFFh
IOFF0l
TXSLPh
TXSLPl
TXOFFh
TXOFFl
Temperature offset (six-bit signed offset, .5 C resolution)
Not used
Voltage slope, high byte
Voltage slope, low byte
Voltage offset, high byte
Voltage offset, low byte
Bias current slope, high byte
Bias current slope, low byte
Bias current offset, high byte
Bias current offset, low byte
TX Power slope, high byte
TX Power slope, low byte
TX Power offset, high byte
TX Power offset, low byte
Manufacturer ID Register (MFG_ID)
Identifies Micrel as the manufacturer of the device. Always returns 2Ah
D[7]
read-only
Default value
Serial address
Byte address
D[6]
read-only
D[5]
read-only
D[4]
D[3]
read-only
read-only
0010 1010b = 2Ah
A6h
254 = FEh
D[2]
read-only
D[1]
read-only
D[0]
read-only
The value in this register, in combination with the DEV_ID register, serves to identify the MIC3003 and its revision number to
software.
This register is read-only.
Bit(s)
D[7:0]
Function
Identifies Micrel as the manufacturer of the device. Always
returns 2Ah.
Operation
Read-only. Always returns Ah
July 2010
72
M9999-072910-A
hbwhelp@micrel.com or (408) 955-1690