English
Language : 

MLX90132 Datasheet, PDF (25/44 Pages) Melexis Microelectronic Systems – 13.56MHz RFID / NFC Transceiver
MLX90132
13.56MHz RFID / NFC Transceiver
6.8 Send command (0x06)
This command is used with the MLX90132 in TAG emulation state, to send data back to the reader. This
command sends specific protocol data without waiting for an answer.
Send 0x06
Direction
MCU – device
Data
06
<Len>
<Data>
Device - MCU
00
00
82
Device - MCU 00
Device - MCU
83
00
Comments
Command code
Length of data
Data to be sent
Result code
Length of data
Error code
Length of data
Error code
Length of data
Example
Depends on protocol previously selected!
040C50920E997500000000B37171 – Emulation of TAG response in
ISO14443-B protocol
0000 - Data was successfully sent
8200 - Invalid length
8300 - Invalid protocol previously selected by Select Protocol command
Table 21: “Send” command description
Format of data to be sent using ‘Send’ command
Protocol Explanation
Response example
Send example
06 03 0400 08
Command code
Length of entire data field
ISO14443A Data
NFC-A 7:6 – RFU
5 – Append CRC
4 – RFU
3:0 – number of significant
bits in first byte
Send example
06 04 01020304
ISO14443B Command code
NFC-B Length of entire data field
Data
Send example
06 05 01020304 00
Command code
Length of entire data field
ISO18092 Data
(212,424Kb)
NFC-F
Slot number (in which to reply)
Comments
The anti-collision filter could be activated with the
command “AcFilter”. In this case, the complete
anti-collision process is supported by the
MLX90132 as soon as a “Listen” command is
initiated. The information will be automatically sent
by the MLX90132
The number of slot in which to reply is entered by
the application in the field <Slot number>. In this
case, the MLX90132 automatically manages the
related timings defined by the protocol, to answer
to the corresponding slot. This parameter is used
for the Single Device Detection (SDD) process,
For other commands, the field <Slot number>
should simply be set to zero.
Table 22: Format of data to be sent using “Send” command
3901090132
Rev. 009
Page 25 of 44
Jan-2014