MAX1513 Datasheet, PDF (9/28 Pages) Maxim Integrated Products – TFT-LCD Power-Supply Controllers

TFT-LCD Power-Supply Controllers
Pin Description (continued)
NAME
PIN
MAX1513 MAX1514
FUNCTION
8
DRVN
DRVN
REG N Base Drive. Open drain of an internal P-channel MOSFET. Connect to the base of an
external NPN linear-regulator pass transistor.
9
DRVL
DRVL
Logic Linear-Regulator (REG L) Base Drive. Open drain of an internal N-channel MOSFET. Connect
to the base of an external PNP linear-regulator pass transistor.
10
FBL
REG L Feedback Input. FBL regulates to 1.25V (typ). Connect to the center tap of a resistive
FBL voltage-divider between the REG L output and the analog ground plane to set the output voltage.
Place the resistive voltage-divider close to this pin.
11 DRVG
N.C.
Gamma Linear-Regulator (REG G) Base Drive for the MAX1513. Open drain of an internal N-channel
MOSFET. Connect to the base of an external PNP linear-regulator pass transistor. Not internally
connected for the MAX1514.
12
FBG
N.C.
REG G Feedback Input for MAX1513. FBG regulates to 1.25V (typ). Connect to the center tap of a
resistive voltage-divider between the REG G output and the analog ground plane to set the output
voltage. Place the divider close to the FBG pin. Not internally connected for the MAX1514.
13
FBP
Gate-On Linear-Regulator (REG P) Feedback Input. FBP regulates to 1.25V (typ). Connect to the
FBP center tap of a resistive voltage-divider between the REG P output and the analog ground plane to
set the output voltage. Place the resistive-divider close to this pin.
14
DRVP
15
GND
16
GATE
17
IN
DRVP
GND
GATE
IN
REG P Base Drive. Open drain of an internal N-channel MOSFET. Connect to the base of an
external PNP linear-regulator pass transistor.
Ground
External MOSFET Gate Drive. Drives the gate of the step-up switching regulator’s MOSFET.
Supply Input. IN powers all the internal circuitry of the MAX1513/MAX1514. The input voltage range
is from 2.7V to 5.5V. Bypass with a 0.1µF ceramic capacitor between IN and GND. Place the
capacitor within 5mm of IN.
18
CS+
19
CS-
20
FB
CS+
CS-
FB
Current-Sense-Comparator Noninverting Input. Connect CS+ and CS- to the lossless current-sense
network. See the Lossless Current Sense section.
Current-Sense-Comparator Inverting Input. Connect CS+ and CS- to the lossless current-sense
network. See the Lossless Current Sense section.
Main Step-Up Regulator Feedback Input. FB regulates to 1.25V (typ). Connect to the center tap of a
resistive voltage-divider between the main output (V_MAIN) and the analog ground plane to set the
main step-up regulator output voltage. Place the resistive-divider close to this pin.
_______________________________________________________________________________________ 9