Z86L88 Datasheet, PDF (70/80 Pages) Zilog, Inc. – INFRARED REMOTE CONTROLLERS

Z86L88
Low-Voltage IR Microcontroller
63
Table 23. Stop-Mode Recovery Source
SMR:432
Operation
D4
D3
D2
Description of Action
0
0
0 POR and/or external reset recovery
0
0
1 Reserved
0
1
0 P31 transition
0
1
1 P32 transition
1
0
0 P33 transition
1
0
1 P27 transition
1
1
0 Logical NOR of P20 through P23
1
1
1 Logical NOR of P20 through P27
Note: Any Port 2 bit defined as an output drives the corresponding
input to the default state to allow the remaining inputs to control
the AND/OR function. Refer to “Stop-Mode Recovery Register
2 (SMR2)” on page 64 for other recover sources.
Stop-Mode Recovery Delay Select (D5)
This bit, if low, disables the 5-ms RESET delay after Stop-Mode Recovery. The
default configuration of this bit is 1. If the “fast” wake up is selected, the Stop-
Mode Recovery source must be kept active for at least 5TpC.
Stop-Mode Recovery Edge Select (D6)
A 1 in this bit position indicates that a High level on any one of the recovery
sources wakes the Z86L88 from STOP Mode. A 0 indicates Low level recovery.
The default is 0 on POR.
Cold or Warm Start (D7)
This bit is read only. It is set to 1 when the device is recovered from Stop Mode.
The bit is set to 0 when the device is reset other than Stop-Mode Recovery
(SMR).
19-4614; Rev 0; 4/09