MAX16070 Datasheet, PDF (5/52 Pages) Maxim Integrated Products – 12-Channel/8-Channel, Flash-Configurable System Monitors with Nonvolatile Fault Registers

12-Channel/8-Channel, Flash-Configurable System
Managers with Nonvolatile Fault Registers
ELECTRICAL CHARACTERISTICS (continued)
(VCC = 2.8V to 14V, TA = -40NC to +85NC, unless otherwise specified. Typical values are at VABP = VDBP = VCC = 3.3V, TA = +25NC.)
(Note 1)
PARAMETER
Output Fall Time
Data Hold Time
Pulse Width of Spike Suppressed
JTAG INTERFACE
TDI, TMS, TCK Logic-Low Input
Voltage
SYMBOL
tOF
tHD:DAT
tSP
CONDITIONS
CBUS = 10pF to 400pF
From 50% SCL falling to SDA change
VIL
Input voltage falling
MIN TYP MAX UNITS
250
ns
0.3
0.9
μs
30
ns
0.8
V
TDI, TMS, TCK Logic-High Input
Voltage
TDO Logic-Output Low Voltage
TDO Logic-Output High Voltage
TDI, TMS Pullup Resistors
I/O Capacitance
TCK Clock Period
TCK High/Low Time
TCK to TMS, TDI Setup Time
TCK to TMS, TDI Hold Time
TCK to TDO Delay
TCK to TDO High-Z Delay
VIH
VOL
VOH
RPU
CI/O
t1
t2, t3
t4
t5
t6
t7
Input voltage rising
ISINK = 3mA
ISOURCE = 200μA
Pullup to DBP
2
V
0.4
V
2.4
V
40
50
60
kω
5
pF
1000
ns
50
500
ns
15
ns
10
ns
500
ns
500
ns
Note 1: Specifications are guaranteed for the stated global conditions, unless otherwise noted. 100% production tested at TA =
+25NC and TA = +85NC. Specifications at TA = -40NC are guaranteed by design.
Note 2: For 3.3V VCC applications, connect VCC, DBP, and ABP together. For higher supply applications, connect VCC only to the
supply rail.
Note 3: Applies to RESET, fault, autoretry, sequence delays, and watchdog timeout.
Note 4: Total unadjusted error is a combination of gain, offset, and quantization error.
_______________________________________________________________________________________   5