DS8313 Datasheet, PDF (2/18 Pages) Maxim Integrated Products – Smart Card Interface

Smart Card Interface
ABSOLUTE MAXIMUM RATINGS
Voltage Range on V_DD Relative to GND ...............-0.5V to +6.5V
Voltage Range on V_DDA Relative to GND .............-0.5V to +6.5V
Voltage Range on All Other Pins
Relative to GND......................................-0.5V to (V_DD + 0.5V)
Maximum Junction Temperature .....................................+125°C
Maximum Power Dissipation (T_A = -25°C to +85°C) .......700mW
Storage Temperature Range .............................-55°C to +150°C
Soldering Temperature.........Refer to the IPC/JEDEC J-STD-020
Specification.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
RECOMMENDED DC OPERATING CONDITIONS
(V_DD = +3.3V, V_DDA = +5.0V, T_A = +25°C, unless otherwise noted. All specifications apply to both the DS8313 and DS8314, unless
otherwise noted in the CONDITIONS column.) (Note 1)
PARAMETER
POWER SUPPLY
Digital Supply Voltage
Card Voltage-Generator Supply Voltage
Reset Voltage Thresholds
CURRENT CONSUMPTION
Active V_DD Current 5V Cards
(Including 80mA Draw from 5V Card)
Active V_DD Current 5V Cards (Current
Consumed by DS8313/DS8314 Only)
Active V_DD Current 3V Cards
(Including 65mA Draw from 3V Card)
Active V_DD Current 3V Cards (Current
Consumed by DS8313/DS8314 Only)
Active V_DD Current 1.8V Cards
(Including 30mA Draw from 1.8V Card)
Active V_DD Current 1.8V Cards (Current
Consumed by DS8313/DS8314 Only)
Inactive-Mode Current
Stop-Mode Current
SYMBOL
CONDITIONS
MIN TYP MAX UNITS
V_DD
V_DDA
V_TH2
V_HYS2
DS8313, DS8314
Threshold voltage (falling)
Hysteresis
2.7
6.0
V
4.75
6.0
V
2.35 2.45 2.65
V
50 100 150 mV
I_{DD_50V}
I_{DD_IC}
I_{DD_30V}
I_{DD_IC}
I_{DD_18V}
I_{DD_IC}
I_DD
I_{DD_STOP}
I_CC = 80mA, f_XTAL = 20MHz,
f_CLK = 10MHz, V_DDA = 5.0V
I_CC = 80mA, f_XTAL = 20MHz,
f_CLK = 10MHz, V_DDA = 5.0V (Note 2)
I_CC = 65mA, f_XTAL = 20MHz,
f_CLK = 10MHz, V_DDA = 5.0V
I_CC = 65mA, f_XTAL = 20MHz,
f_CLK = 10MHz, V_DDA = 5.0V (Note 2)
I_CC = 30mA, f_XTAL = 20MHz,
f_CLK = 10MHz, V_DDA = 5.0V
I_CC = 30mA, f_XTAL = 20MHz,
f_CLK = 10MHz, V_DDA = 5.0V (Note 2)
Card inactive, active-high PRES,
DS8313/DS8314 not in stop mode
DS8313/DS8314 in ultra-low-power
stop mode (CMDVCC, 5V/3V, and
1_8V set to logic 1) (Note 3)
80.75 85
mA
0.75
5
mA
65.75 70
mA
0.75
5
mA
30.75 40
mA
0.75
5
mA
50
40
μA
10
μA
2 _______________________________________________________________________________________