MAX1204 Datasheet, PDF (19/24 Pages) Maxim Integrated Products – 5v, 8-cHANNEL, sERIAL, 10-bIT adc WITH 3v dIGITAL iNTERFACE

5V, 8-Channel, Serial, 10-Bit ADC
with 3V Digital Interface
FULL POWER-DOWN
1000
2ms FASTPD WAIT
400kHz EXTERNAL CLOCK
INTERNAL COMPENSATION
8 CHANNELS
100
1 CHANNEL
10
1
0
50 100 150 200 250 300 350 400 450 500
CONVERSIONS PER CHANNEL PER SECOND
3.0
2.5
2.0
1.5
1.0
0.5
0
0.0001 0.001 0.01 0.1
1
10
TIME IN SHUTDOWN (sec)
Figure 14a. MAX1204 Supply Current vs. Sample Rate/Second,
FULLPD, 400kHz Clock
Figure 14c. Typical Power-Up Delay vs. Time in Shutdown
10,000
FAST POWER-DOWN
1000
8 CHANNELS
1 CHANNEL
100
2MHz EXTERNAL CLOCK
EXTERNAL COMPENSATION
50µs WAIT
10
0
2k 4k 6k 8k 10k 12k 14k 16k 18k
CONVERSIONS PER CHANNEL PER SECOND
Figure 14b. MAX1204 Supply Current vs. Sample Rate/Second,
FASTPD, 2MHz Clock
Figure 17, the Reference-Adjust Circuit, shows how to
adjust ADC gain in applications that use the internal
reference. The circuit provides ±1.5% (±16LSBs) of
gain-adjustment range.
Layout, Grounding, Bypassing
For best performance, use printed circuit boards.
Wire-wrap boards are not recommended. Board layout
should ensure that digital and analog signal lines are
separated from each other. Do not run analog and digital
(especially clock) lines parallel to one another, or digital
lines underneath the ADC package.
Figure 18 shows the recommended system-ground con-
nections. Establish a single-point analog ground (star
ground point) at GND. Connect all other analog grounds
to this ground. No other digital system ground should be
connected to this single-point analog ground. The
ground return to the power supply should be low imped-
ance and as short as possible for noise-free operation.
High-frequency noise in the V_DD power supply may affect
the high-speed comparator in the ADC. Bypass these
supplies to the single-point analog ground with 0.1µF and
4.7µF bypass capacitors close to the MAX1204. Minimize
capacitor lead lengths for best supply-noise rejection. If
the +5V power supply is very noisy, a 10Ω resistor can
be connected as a lowpass filter, as shown in Figure 18.
______________________________________________________________________________________ 19