MAX1471_11 Datasheet, PDF (15/26 Pages) Maxim Integrated Products – 315MHz/434MHz Low-Power, 3V/5V ASK/FSK Superheterodyne Receiver

315MHz/434MHz Low-Power, 3V/5V
ASK/FSK Superheterodyne Receiver
MAX1471
DATA ^{MAXIMUM PEAK}
SLICER
DETECTOR
MINIMUM PEAK
DETECTOR
ADATA
FDATA
PDMAXA
PDMAXF
R
C
PDMINA
PDMINF
R
C
Figure 5. Generating Data-Slicer Threshold Using the Peak Detectors
BASEBAND
FILTER
MINIMUM PEAK
DETECTOR
PDMINA
PDMINF
TRK_EN = 1
MAXIMUM PEAK
DETECTOR
PDMAXA
PDMAXF
TO SLICER
INPUT
MAX1471
TRK_EN = 1
Figure 6. Peak-Detector Track Enable
Power-Supply Connections
The MAX1471 can be powered from a 2.4V to 3.6V
supply or a 4.5V to 5.5V supply. The device has an on-
chip linear regulator that reduces the 5V supply to 3V
needed to operate the chip.
To operate the MAX1471 from a 3V supply, connect
DVDD, AVDD, and HVIN to the 3V supply. When using
a 5V supply, connect the supply to HVIN only and con-
nect AVDD and DVDD together. In both cases, bypass
DVDD and HVIN with a 0.01µF capacitor and AVDD
with a 0.1µF capacitor. Place all bypass capacitors as
close as possible to the respective supply pin.
Control Interface Considerations
When operating the MAX1471 with a +4.5V to +5.5V
supply voltage, the CS, DIO, and SCLK pins can be dri-
ven by a microcontroller with either 3V or 5V interface
logic levels. When operating the MAX1471 with a +2.4V
to +3.6V supply, only 3V logic from the microcontroller
is allowed.
______________________________________________________________________________________ 15