MAX16047A Datasheet, PDF (11/61 Pages) Maxim Integrated Products – 12-Channel/8-Channel EEPROM-Programmable System Managers with Nonvolatile Fault Registers

12-Channel/8-Channel EEPROM-Programmable
System Managers with Nonvolatile Fault Registers
Pin Description
PIN
MAX16047A MAX16049A
NAME
FUNCTION
1–8
1–8
MON1–MO
N8
ADC Monitored Voltage Inputs. Set ADC input range for each MON_ through
configuration registers. Measured values are written to ADC registers and can be read
back through the I²C or JTAG interface.
9–12
13
14
15
16
17
18
19
20
21, 40
22
23
—
13
14
15
16
17
18
19
20
21, 40
22
23
ADC Monitored Voltage Inputs. Set ADC input range through configuration registers.
MON9–MO
N12
Measured values are written to ADC registers and can be read back through the I²C or
JTAG interface.
RESET Configurable Reset Output
Four-State SMBus Address. Address sampled upon POR. Connect A0 to ground, DBP,
A0
SCL, or SDA to program an individual address when connecting multiple devices. See
the I²C/SMBus-Compatible Serial Interface section.
SCL
SDA
TMS
TDI
TCK
TDO
GND
SMBus Serial Clock Input
SMBus Serial Data Open-Drain Input/Output
JTAG Test Mode Select
JTAG Test Data In
JTAG Test Clock
JTAG Test Data Out
Ground. Connect all GND connections together.
GPIO6
GPIO5
General-Purpose Input/Output. GPIO6 and GPIO5 are configurable as open-drain or
push-pull outputs, dedicated fault outputs, or for watchdog functionality. GPIO5 is
configurable as a watchdog input (WDI). GPIO6 is configurable as a watchdog output
(WDO). GPIO6 is also configurable for margining. Use the EEPROM to configure GPIO5
and GPIO6. See the General-Purpose Inputs/Outputs section.
Analog Enable Input. Apply a voltage greater than the 0.525V (typ) threshold to enable
24
24
EN
all outputs. The power-down sequence is triggered when EN falls below 0.5V (typ) and
all outputs are deasserted.
25–36
9–12, 25–36,
53–56
N.C.
No Connection. Must be left unconnected.
______________________________________________________________________________________ 11