88F6190_1 Datasheet, PDF (92/150 Pages) –

10.5
88F619x
Hardware Specifications
DC Electrical Specifications
10.5.1
Note
See Section 2.3, Internal Pull-up and Pull-down Pins, on page 55 for internal
pullup/pulldown information.
General 3.3V (CMOS) DC Electrical Specifications
Note
The S/PDIF / I2S and Transport Stream interfaces are only relevant for the 88F6192.
The DC electrical specifications in Table 45 are applicable for the following interfaces and signals:
„ JTAG
„ RGMII (10/100 Mbps)/GMII/MII/MMII
„ Secure Digital Input/Output (SDIO)
„ S/PDIF / I²S (Audio)
„ Transport Stream (TS)
„ NAND flash
„ UART
„ MPP
„ PTP
„ SYSRSTn
In the following table, for the JTAG, SDIO, S/PDIF / I²S, TS, NAND flash, UART, PTP, and MPP
interfaces, VDDIO means the VDDO power rail. For the 88F6190 RGMII interface VDDIO means the
VDD_GE_A power rail, and for the GMII/MII/MMII interface, VDDIO means the VDD_GE_A and
VDD_GE_B power rails. For the 88F6192 RGMII/GMII/MII/MMII interface, VDDIO means the
VDD_GE_A and VDD_GE_B power rails.
Table 45: General 3.3V Interface (CMOS) DC Electrical Specifications
Param eter
Input low level
Input high level
Output low level
Output high level
Input leakage current
Pin capacitance
Sym bol Test Condition
VIL
VIH
VOL IOL = 2 mA
VOH IOH = -2 mA
IIL 0 < VIN < VDDIO
Cpin
M in
Typ
M ax
Units Notes
-0.3
0.8
V
-
2.0
VDDIO+0.3 V
-
-
0.4
V
-
2.4
-
V
-
-10
10
uA 1, 2
5
pF -
Note s :
General comment: See the Pin Description section for internal pullup/pulldow n.
1. While I/O is in High-Z.
2. This current does not include the current flow ing through the pullup/pulldow n resistor.
Doc. No. MV-S104987-U0 Rev. F
Page 92
Document Classification: Proprietary Information
Copyright © 2008 Marvell
December 2, 2008, Preliminary