M02016 Datasheet, PDF (4/20 Pages) M/A-COM Technology Solutions, Inc. – CMOS Transimpedance Amplifier with AGC for Fiber Optic Networks up to 1.25 Gbps

M02016
CMOS Transimpedance Amplifier with AGC
for Fiber Optic Networks up to 1.25 Gbps
1.3
DC Characteristics
Table 1-3. DC Characteristics
Symbol
Parameter
V_B
Photodiode bias voltage (PINK – PINA)
V_CM
Common mode output voltage
I_CC
Supply current (no loads)
R_LOAD
Recommended differential output loading
NOTE:
1. 100Ω is the load presented by the limiting amplifier.
Rev V4
Minimum
1.7
0.7
23
—
Typical
2.0
1
30
100 ⁽¹⁾
Maximum
2.2
1.3
39
—
Units
V
V
mA
Ω
1.4
AC Characteristics
Table 1-4. AC Characteristics
Symbol
Parameter
Minimum Typical⁽¹⁾ Maximum
Units
R_OUT
LFC
Output impedance (single ended) ⁽²⁾
Low frequency cutoff ⁽³⁾
35
50
65
Ω
—
70
115
kHz
V_D
Differential output voltage
DCD
Duty cycle distortion
—
275
500
mV
—
—
40
ps
DJ
In_rms
Pin
PIN_mean_min
Deterministic jitter (includes DCD)
Total input RMS noise, DC to 930 MHz, Cin = 0.5 pF
Example dynamic range of optical input ⁽⁴⁾
Optical Sensitivity ⁽⁴⁾
—
—
80
ps_PP
—
130
185
nA
–28
—
+6
dBm
—
–29
—
dBm
NOTES:
1. Die designed to operate over an ambient temperature range of –40°C to +85°C, T_A and V_CC range from 3.0–3.6V. Typical values are tested at T_A =
25°C and V_CC= 3.3V.
2. Measured at 1 MHz.
3. Input –28 dBm, Extinction Ratio = 10, Temp = 25°C.
4. BER 10^–10, PD capacitance = 0.5 pF, Responsivity 0.9 A/W, Extinction Ratio = 10.
4
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support