M02016 Datasheet, PDF (1/20 Pages) M/A-COM Technology Solutions, Inc. – CMOS Transimpedance Amplifier with AGC for Fiber Optic Networks up to 1.25 Gbps

M02016
CMOS Transimpedance Amplifier with AGC
for Fiber Optic Networks up to 1.25 Gbps
Rev V4
Applications
• GPON
• GEPON
• Gigabit Ethernet
• Fiber Channel
Features
• Typical –29dBm sensitivity, +6 dBm saturation at 1.25
Gbps when used with 0.9 A/W InGaAs PIN.
(Cpd ≤ 0.5pF, BER 10^–10)
• Typical differential transimpedance: 24 kΩ
• Fabricated in standard CMOS
• Differential output
• Standard +3.3 Volt supply
• Available in die form only
• Monitor output
• AGC provides dynamic range of 35 dB
• Internal or external bias for photodiode
• PIN or APD sensor
• Same pad layout and die size as M02011/13/14/15
The M02016 is a CMOS transimpedance amplifier with AGC. The AGC gives a wide dynamic range of 35 dB. The
high transimpedance gain of 24 kΩ ensures good sensitivity.
For optimum system performance, the M02016 die should be mounted with a silicon or InGaAs PIN photo detector
inside a lensed TO-Can or other optical sub-assembly.
The M02016 can either bias the PIN diode from the internal regulator or use an externally biased PIN diode.
A replica of the average photodiode current is available at the MON pad for photo-alignment.
Typical Applications Diagram
V_CC
1 nF
V_CC
PINK
DOUT
Typically
AC-Coupled
to Limiting
Amplifier
470 pF _M02016
Limiting
Amplifier
PINA
GND
DOUTB
TIA Bond Pad
TO Can Lead
1
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support