M02016 Datasheet, PDF (14/20 Pages) M/A-COM Technology Solutions, Inc. – CMOS Transimpedance Amplifier with AGC for Fiber Optic Networks up to 1.25 Gbps

M02016
CMOS Transimpedance Amplifier with AGC
for Fiber Optic Networks up to 1.25 Gbps
4.2
TO-Can Layout
Figure 4-2. Typical Layout Diagram
GND
GND
DOUT
1nF
470pF
DOUTB
VCC
MON
Rev V4
Notes:
Typical application inside of a 5 lead TO-Can.
Only one of the V_CC pads and one of the GND pads need to be connected (though in noisy environments two or
more GND pads connected may improve performance). The backside must be connected to the lowest potential,
usually ground, with conductive epoxy or a similar die attach material. If a monitor output is not required then a 4
lead TO-Can may be used.
4.3
Treatment of PINK
PINK requires bypassing to ground with a capacitor when powering a photo diode. If PINK is not used to bias the
photo diode, then it is not necessary to bypass an unused PINK.
14
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support