LTC3829_15 Datasheet, PDF (33/40 Pages) Linear Technology – 3-Phase, Single Output Synchronous Step-Down DC/DC Controller with Diffamp

LTC3829
APPLICATIONS INFORMATION
Checking Transient Response
The regulator loop response can be checked by looking at
the load current transient response. Switching regulators
take several cycles to respond to a step in DC (resistive)
load current. When a load step occurs, V_OUT shifts by an
amount equal to ∆I_{LOAD (ESR)}, where ESR is the effective
series resistance of C_OUT . ∆I_LOAD also begins to charge or
discharge C_OUT generating the feedback error signal that
forces the regulator to adapt to the current change and
return V_OUT to its steady-state value. During this recovery
time V_OUT can be monitored for excessive overshoot or
ringing, which would indicate a stability problem. The
availability of the I_TH pin not only allows optimization of
control loop behavior but also provides a DC-coupled and
AC-filtered closed-loop response test point. The DC step,
rise time and settling at this test point truly reflects the
closed-loop response. Assuming a predominantly second
order system, phase margin and/or damping factor can be
estimated using the percentage of overshoot seen at this
pin. The bandwidth can also be estimated by examining the
rise time at the pin. The I_TH external components shown
in the Typical Application circuit will provide an adequate
starting point for most applications. The I_TH series R_C-C_C
filter sets the dominant pole-zero loop compensation.
The values can be modified slightly (from 0.5 to 2 times
their suggested values) to optimize transient response
once the final PC layout is done and the particular output
capacitor type and value have been determined. The output
capacitors need to be selected because the various types
and values determine the loop gain and phase. An output
current pulse of 20% to 80% of full-load current having a
rise time of 1µs to 10µs will produce output voltage and
I_TH pin waveforms that will give a sense of the overall
loop stability without breaking the feedback loop. Placing
a power MOSFET directly across the output capacitor and
driving the gate with an appropriate signal generator is a
practical way to produce a realistic load step condition. The
initial output voltage step resulting from the step change
in output current may not be within the bandwidth of the
feedback loop, so this signal cannot be used to determine
phase margin. This is why it is better to look at the I_TH
pin signal which is in the feedback loop and is the filtered
and compensated control loop response. The gain of the
loop will be increased by increasing R_C and the bandwidth
of the loop will be increased by decreasing C_C. If R_C is
increased by the same factor that C_C is decreased, the
zero frequency will be kept the same, thereby keeping the
phase shift the same in the most critical frequency range
of the feedback loop. The output voltage settling behavior
is related to the stability of the closed-loop system and
will demonstrate the actual overall supply performance.
A second, more severe transient is caused by switching
in loads with large (>1µF) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C_OUT , causing a rapid drop in V_OUT . No regulator can
alter its delivery of current quickly enough to prevent this
sudden step change in output voltage if the load switch
resistance is low and it is driven quickly. If the ratio of
C_LOAD to C_OUT is greater than 1:50, the switch rise time
should be controlled so that the load rise time is limited
to approximately 25 • C_LOAD. Thus a 10µF capacitor would
require a 250µs rise time, limiting the charging current
to about 200mA.
For more information www.linear.com/LTC3829
3829fc
33