E6704A Datasheet, PDF (5/15 Pages) Keysight Technologies – E6702G cdma2000/IS-95/AMPS

05 | Keysight | E6702F cdma2000/IS-95/AMPS Lab Application - Technical Overview
Technical Specifications
These specifications apply to E5515E, or an E5515C mainframe with Option 003, for serial number
US40410101, GB40410101, or higher when used with an E6702G lab application of firmware.
Specifications describe the test set’s warranted performance and are valid for the unit’s operation
within the stated environmental range unless otherwise noted. All specifications are valid after a
30-minute warm-up period of continuous operation.
Supplemental characteristics are intended to provide typical, but non-warranted, performance pa-
rameters that may be useful in applying the instrument. These characteristics are shown in italics and
labeled as “typical”. All units shipped from the factory meet these typical numbers at 25 °C ambient
temperature without including measurement uncertainty.
Additionally, these specifications apply to an E5515C/E mainframe with Option 003 running an E6702T
lab application with firmware revision T.01.12 over the 25 °C ±5 °C ambient temperature range. The
E6702T operating conditions are 0 to 35 °C.
WAP push message pipe
Functionality: Used to send user-defined
messages over the data burst message
channel
–– Send custom automation commands to the phone for
application control and automation
–– Call must be connected for the data burst message to be sent
–– Use standard web browser to send command
A-GPS message pipe
Functionality: Send any desired, exter-
nally coded, PDDM message. Receive and
retrieve up to 10 PDDM messages from
the DUT. Received message must also be
externally decoded
Instrument IP addresses
User parameters
Displays
SO33 data channel
SO33 data channel operation
SO33 dormant mode
IP throughput monitor
IP throughput monitor numeric results
IP throughput monitor display axis controls
IP throughput monitor trace controls
IP throughput monitor graph controls
–– Send control plane messages for GPS acquisition
assistance
–– Support for TIA-801 messaging
–– RUI interface over GPIB
IPv6 prefix, IPv6 default router address
IPv6 link-local prefix, LAN IPv6 IID (derived from MAC ID), LAN 2
IPv6 IID (derived from MAC ID)
Allows the test set to emulate a complete data network by providing
transparent connectivity to a packet data capable mobile; supports
simple IP and mobile IP connections; requires that the test set be
connected to an external server via the rear panel LAN connector
Supported
Displays a graph of the data throughput for forward and reverse
packets at the IP layer and at the RLP layer
Provides numeric results for the current, average, and peak data
rates in bits per second as well as total number of bytes transferred
for forward and reverse IP packets and forward and reverse OTA
(over the air-RLP) packets
Time span: 0 to 600 s
Start data rate: 0 to 600 kbps
Stop data rate: 0 to 600 kbps
On/off function and marker function for IP Tx trace, IP Rx trace, OTA
(RLP) Tx trace, and OTA (RLP) Rx trace
Clear display and freeze display