E6719J Datasheet, PDF (14/16 Pages) Keysight Technologies – E6706G 1xEV-DO Lab Application

14 | Keysight | E6706G 1xEV-DO Lab Application - Technical Overview
1xEV-DO enhanced multi-flow packet application (continued)
Enhanced multi-flow packet application (continued)
Traffic channel MAC
Supports each of the 4 RTC MAC subtype 3 flows the follow-
pre-configurations
ing pre-configurations: Preset with maximum throughput,
IS-856 protocol default values, SIP/RTCP, video 64 kbps,
audio for video at 64 kbps, best effort, gaming, and voice
over IP
Forward traffic MAC parameters
DRC supervision timer and minimum continuation span
RTC MAC non-flow parameters
Same as listed under MFPA
Flow NN simple parameters
Same as listed under MFPA
Flow NN complex parameters
Same as listed under MFPA
1xEV-DO alternate enhanced multi-flow packet application
Alternate enhanced multi-flow packet application
Protocol stack
1xEV-DO Release A only
Alternate enhanced multi-flow packet Allows the test set to emulate a complete eHRPD data net-
application operation
work by providing transparent connectivity to a 1xEV-DO AT.
In alternate EMPA (eHRPD) mode, the test sets the FlowNN
protocol ID to 7. In this mode the test set supports the new
VSNCP protocol and internal eAN/ePCF plus HSGW func-
tions. In alternate EMPA mode the test set supports multiple
IP flows in both the forward and reverse links with RoHC and
quality of service. Requires that the test be connected to a
external servers (SIP and application) via the rear panel LAN
connector
Air interface support
Supports all physical layer subtype 2 parameters and
functionality
IP flows
Supports up to 16 forward and reverse IP flows
RLP flows
Supports 5 forward RLP flows and 5 reverse RLP flows
RTC MAC subtype 3 flows
Supports 4 user-configurable RTCMAC subtype 3 flows
Forward mapping rule parameters Same as listed under EMPA
Reverse mapping rule parameters
Same as listed under EMPA
Forward link flow parameters
Same as listed under EMPA
Reverse link flow parameters
Same as listed under EMPA
Robust header compression (RoHC) Same as listed under EMPA
Data throughput monitor
Same as listed under EMPA
Session application
Same as listed under EMPA
pre-configurations
Traffic channel MAC
Same as listed under EMPA P
pre-configurations
Forward traffic MAC parameters
DRC supervision timer and minimum continuation span
RTC MAC non-flow parameters
Same as listed under MFPA
Flow NN simple parameters
Same as listed under MFPA
Flow NN complex parameters
Same as listed under MFPA
EAP-AKA’ parameters
Authentication state
On or Off (default)
Authentication key (K) (hex)
32 hex character user input with default value of
“4147494C454E5420544543484E4F0000”
Operator variant algorithm
32 hex character user input with default value of “0000000
config field (OP) (hex)
0000000000000000000000000”
Authentication management
4 hex character user input with default value of “8000”
field (AMF) (hex)
Reset authentication SQN
User command to reset the SQN value