C0603C104J3RECAUTO Datasheet, PDF (5/18 Pages) Kemet Corporation – Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
ESD, C0G Dielectric, 25 – 200 VDC (Commercial & Automotive Grade)
Qualification/Certification
Commercial Grade products are subject to internal qualification. Details regarding test methods and conditions are
referenced in Table 4, Performance & Reliability.
Automotive Grade products meet or exceed the requirements outlined by the Automotive Electronics Council. Details
regarding test methods and conditions are referenced in document AEC–Q200, Stress Test Qualification for Passive
Components. For additional information regarding the Automotive Electronics Council and AEC–Q200, please visit their
website at www.aecouncil.com.
Environmental Compliance
Lead (Pb)-free, RoHS, and REACH compliant without exemptions.
Electrical Parameters/Characteristics
Item
Parameters/Characteristics
Operating Temperature Range −55°C to +125°C
Capacitance Change with Reference to
+25°C and 0 VDC Applied (TCC)
±30 ppm/ºC
Aging Rate (Maximum % Capacitance Loss/Decade Hour)
1_{Dielectric Withstanding Voltage (DWV)}
2_{Dissipation Factor (DF) Maximum Limit at 25°C}
3_{Insulation Resistance (IR) Minimum Limit at 25°C}
0%
250% of rated voltage
(5±1 seconds and charge/discharge not exceeding 50mA)"
0.1%
1,000 megohm microfarads or 100 GΩ
(Rated voltage applied for 120±5 seconds at 25°C)
1 _{DWV is the voltage a capacitor can withstand (survive) for a short period of time. It exceeds the nominal and continuous working voltage of the}
capacitor.
2 _{Capacitance and dissipation factor (DF) measured under the following conditions:}
1 MHz ±100 kHz and 1.0 ±0.2 Vrms if capacitance ≤ 1,000 pF
1 kHz ±50 Hz and 1.0 ±0.2 Vrms if capacitance > 1,000 pF
3 _{To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.}
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known
as Automatic Level Control (ALC). The ALC feature should be switched to "ON."
Post Environmental Limits
Dielectric
C0G
Rated DC
Voltage
All
Post Environmental Limits
Capacitance
Dissipation Factor
(Maximum %)
All
0.5
Capacitance
Shift
0.3% or
±0.25 pf
Insulation
Resistance
10% of
Initial Limit
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • 864-963-6300 • www.kemet.com
C1091_C0G_ESD • 12/5/2016 5