HMU16JC-35 Datasheet, PDF (9/13 Pages) Intersil Corporation – 16 x 16-Bit CMOS Parallel Multipliers

HMU16, HMU17
Absolute Maximum Ratings
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +8.0V
Input, Output or I/O Voltage Applied
Storage Temperature Range . . . . . .
.
.
.
.
.
.
.
.
.
.
GND
.....
0. ..5.V65to_{oCVCtoC1+500.5oCV}
Operating Conditions
Voltage Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . +4.75V to +5.25V
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0^oC to 70^oC
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA(^oC/W) θ_JC (^oC/W)
PLCC . . . . . . . . . . . . . . . . . . . . . . . . . . 43.2
15.1
CPGA . . . . . . . . . . . . . . . . . . . . . . . . . . 42.69
10.0
Maximum Package Power Dissipation at 70^oC
PLCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.7W
CPGA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.46
Maximum Junction Temperature
PLCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .150^oC
CPGA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 175^oC
Maximum Lead Temperature (Soldering, 10s). . . . . . . . . . . . . 300^oC
Die Characteristics
Gate Count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4500 Gates
CAUTION: Stresses above those listed in the ``Absolute Maximum Ratings'' may cause permanent damage to the device. This is a stress only rating, and operation at
these or any other conditions above those indicated in the operations sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
DC Electrical Specifications
PARAMETER
Logical One Input Voltage
Logical Zero Input Voltage
Output High Voltage
Output Low Voltage
Input Leakage Current
Output or I/O Leakage Current
Standby Power Supply Current
Operating Power Supply Current
V_CC = 5.0V ±5%, T_A = 0^oC to 70^oC
SYMBOL
TEST CONDITIONS
V_IH
V_IL
V_OH
V_OL
I_I
I_O
I_CCSB
V_CC = 5.25V
V_CC = 4.75V
I_OH = 400mA, V_CC = 4.75V
I_OL = +4.0mA, V_CC = 4.75V
V_I = V_CC or GND, V_CC = 5.25V
V_O = V_CC or GND, V_CC = 5.25V
V_I = V_CC or GND, V_CC = 5.25V
Outputs Open
I_CCOP
V_I = V_CC or GND, V_CC = 5.25V
f = 1MHz (Note 2)
MIN
MAX
UNITS
2.0
-
V
-
0.8
V
2.6
-
V
-
0.4
V
10
10
µA
10
10
µA
-
500
µA
-
7.0
mA
NOTE:
2. Operating Supply Current is proportional to frequency, Typical rating is 5mA/MHz.
Capacitance T_A = 25^oC, Note 3
PARAMETER
SYMBOL
TEST CONDITIONS
Input Capacitance
Output Capacitance
C_IN
C_OUT
Frequency = 1MHz. All measurements
referenced to device ground.
I/O Capacitance
C_I/O
NOTE:
3. Not tested, but characterized at initial design and at major process/design changes.
TYPICAL
15
10
10
UNITS
pF
pF
pF
9