ISL29125_14 Datasheet, PDF (4/17 Pages) Intersil Corporation – Digital Red, Green and Blue Color Light Sensor with IR Blocking Filter

ISL29125
I²C Interface Specifications V_DD = 3.0V, T_A = +25°C, 16-bit ADC operation, unless otherwise specified.
SYMBOL
PARAMETER
CONDITIONS
MIN
(Note 6)
MAX
TYP (Note 6) UNITS
VIL
SDA and SCL Input Buffer LOW Voltage
0.55 V
VIH
SDA and SCL Input Buffer HIGH Voltage
1.25
V
VHys (Note 8) SDA and SCL Input Buffer Hysteresis
0.05xVDD
V
VOL (Note 8) SDA Output Buffer LOW Voltage
(open-drain), Sinking 4mA
0
0.4
V
CPIN (Note 8) SDA and SCL Pin Capacitance
fSCL SCL Frequency
T_A = +25°C, f = 1MHz, V_DD = 5V, V_IN = 0V,
V_OUT = 0V
10 pF
500 kHz
t_IN
Pulse Width Suppression Time at SDA and Any pulse narrower than the max spec is
SCL Inputs
suppressed
50 ns
t_AA
SCL Falling Edge to SDA Output Data Valid
t_BUF
Time the Bus Must be Free Before the Start of
a New Transmission
1300
900 ns
ns
t_LOW
SCL LOW Time
t_HIGH
SCL HIGH Time
t_SU:STA START Condition Setup Time
t_HD:STA START Condition Hold Time
t_SU:DAT Input Data Setup Time
t_HD:DAT Input Data Hold Time
t_SU:STO STOP Condition Setup Time
t_HD:STHD:ST STOP Condition Hold Time
t_HD:ST Output Data Hold Time
t_HD:ST (Note 8) SDA and SCL Rise Time
t_HD:ST (Note 8) SDA and SCL Fall Time
Cb (Note 8) Capacitive Loading of SDA or SCL
Total on-chip and off-chip
1300
600
600
600
100
30
600
600
0
20+0.1xCb
20+0.1xCb
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
400 pF
R_PU (Note 8) SDA and SCL Bus Pull-up Resistor Off-chip Maximum is determined by t_R and t_F.
For C_b = 400pF, max is about 2kΩ ~ 2.5kΩ.
1
kΩ
For C_b = 40pF, max is about 15kΩ ~ 20kΩ
NOTES:
8. Limits should be considered typical and are not production tested.
9. These are I²C specific parameters and are not tested, however, they are used to set conditions for testing devices to validate specification.
10. C_b is the capacitance of the bus in pF.
Submit Document Feedback
4
FN8424.2
January 24, 2014