ISL3873A Datasheet, PDF (35/42 Pages) Intersil Corporation – Wireless LAN Integrated Medium Access Controller with Baseband Processor

Bit 3
Bit 2
Bit 1
Bit 0
Bit 7
Bits 6:0
Bits 7:4
Bits 3:0
Bit 7:6
Bit 5:0
Bits 7:4
Bits 3:0
Bits 7:5
Bits 4:0
Bits 7:5
Bit 4:0
Bits 7,6
Bits 5:0
Bits 7,6
Bits 5
Bits 4:0
ISL3873A
CONFIGURATION REGISTER 14 ADDRESS (1Ch) R/W A/D TEST MODES 3 (Continued)
Enable test bus into RX and TX DAC (if below bit 2 is 0).
0 = normal.
1 = enable.
Enable RF A/D into RX DAC.
0 = normal.
1 = enable.
VRbit1.
VRbit0.
CONFIGURATION REGISTER 15 ADDRESS (1Eh) R/W AGC GAIN CLIP
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
AGC gain clip (7-bit value, 0-127) this is the attenuator accumulator upper limit. The lower limit is 0.
CONFIGURATION REGISTER 16 ADDRESS (20h) R/W AGC SATURATION COUNTS
AGC mid Saturation counts (0-15 range) these are the counts to kick in the low and mid attenuator steps (CR28).
AGC low Saturation Count (0-15 range).
CONFIGURATION REGISTER 17 ADDRESS (22h) R/W AGC RF PAD VALUE
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
RXRF_AGC pad value to use in the RSSI calculation, Range 0 - 63dB (nominally 30dB).
CONFIGURATION REGISTER 18 ADDRESS (24h) R/W AGC HI SAT
AGC high saturation attenuation value (0-30).
Note: hi saturation attenuation step actual value is programmed value times 2. This attenuation step will occur if the # of I and
Q sats is greater than hi saturation count.
AGC hi sat count (0-15 range).
CONFIGURATION REGISTER 19 ADDRESS (26h) R/W AGC LOCK IN LEVEL
CW detector scale multiplication factor. (xxxx.x). See CR35 and CR 49.
Set to 00h for forcing CW detect always active.
Set to 0Fh for forcing CW detector always inactive.
AGC Lock-in level (0-7.5 range). Note this is the inner lock window.
CONFIGURATION REGISTER 20 ADDRESS (28h) R/W AGC LOCK WINDOW POS.
AGC max lock count for antenna search. The number of updates required to lock AGC must be less than or equal to this count
for antenna diversity search to be allowed to run. Range 0 to 7.
AGC Lock Window positive side (0-15.5 range). Note: this is the outer lock window.
CONFIGURATION REGISTER 21 ADDRESS (2Ah) R/W AGC BACKOFF
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
AGC Backoff (xxxxx.x, 0-31.5 range) in half dB steps. This sets the operating headroom in the I and Q ADCs.
CONFIGURATION REGISTER 22 ADDRESS (2Ch) R/W AGC LOOKUP TABLE ADDRESS
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
AGC Look up table read control bit.
1 = Read AGC table at address given below.
0 = Read contents of CR23.
AGC lookup table address (32 address bits).
35