English
Language : 

HC5513_03 Datasheet, PDF (2/20 Pages) Intersil Corporation – TR909 DLC/FLC SLIC with Low Power Standby
HC5513
Absolute Maximum Ratings
Operating Temperature Range . . . . . . . . . . . . . . . . -40oC to 110oC
Power Supply (-40oC ≤ TA ≤ 85oC)
Supply Voltage VCC to GND . . . . . . . . . . . . . . . . . . . . 0.5V to 7V
Supply Voltage VEE to GND. . . . . . . . . . . . . . . . . . . . . -7V to 0.5V
Supply Voltage VBAT to GND . . . . . . . . . . . . . . . . . . . -70V to 0.5V
Ground
Voltage between AGND and BGND . . . . . . . . . . . . . -0.3V to 0.3V
Relay Driver
Ring Relay Supply Voltage . . . . . . . . . . . . . . . . . . . . . . 0V to 20V
Ring Relay Current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50mA
Ring Trip Comparator
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VBAT to 0V
Input Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -5mA to 5mA
Digital Inputs, Outputs (C1, C2, E0, E1, DET)
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0V to VCC
Output Voltage (DET Not Active) . . . . . . . . . . . . . . . . . .0V to VCC
Output Current (DET) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mA
Tipx and Ringx Terminals (-40oC ≤ TA ≤ 85oC)
Tipx or Ringx Voltage, Continuous (Referenced to GND) .VBAT to 2V
Tipx or Ringx, Pulse < 10ms, TREP > 10s . . . . . .VBAT -20V to 5V
Tipx or Ringx, Pulse < 10µs, TREP > 10s . . . . VBAT -40V to 10V
Tipx or Ringx, Pulse < 250ns, TREP > 10s. . . . VBAT -70V to 15V
Tipx or Ringx Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70mA
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7) . . . .500V
Thermal Information
Thermal Resistance (Typical, Note 1)
θJAoC/W
22 Lead PDIP Package . . . . . . . . . . . . . . . . . . . . . .
53
Continuous Dissipation at 70oC
22 Lead PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5W
Package Power Dissipation at 70oC, t < 100ms, tREP > 1s
22 Lead PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4W
Derate above . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .70oC
Plastic DIP Package. . . . . . . . . . . . . . . . . . . . . . . . . . 18.8mW/oC
Maximum Junction Temperature Range . . . . . . . . . -40oC to 150oC
Maximum Storage Temperature Range . . . . . . . . . . -65oC to 150oC
Die Characteristics
Gate Count . . . . . . . . . . . . . . . . . . . . . . .543 Transistors, 51 Diodes
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θJA is measured with the component mounted on an evaluation PC board in free air.
Typical Operating Conditions
These represent the conditions under which the part was developed and are suggested as guidelines.
PARAMETER
CONDITIONS
MIN
TYP
MAX
Case Temperature
VCC with Respect to AGND
VEE with Respect to AGND
VBAT with Respect to BGND
-40oC to 85oC
-40oC to 85oC
-40oC to 85oC
-40
-
100
4.75
-
5.25
-5.25
-
-4.75
-58
-
-24
UNITS
oC
V
V
V
Electrical Specifications TA = -40oC to 85oC, VCC = 5V ±5%, VEE = -5V ±5%, VBAT = -28V, AGND = BGND = 0V, RDC1 = RDC2 =
41.2kΩ, RD = 39kΩ, RSG = ∞, RF1 = RF2 = 0Ω, CHP = 10nF, CDC = 1.5µF, ZL = 600Ω.
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
Overload Level
Longitudinal Impedance (Tip/Ring)
1% THD, ZL = 600Ω, (Note 2, Figure 1)
0 < f < 100Hz (Note 3, Figure 2)
3.1
-
-
VPEAK
-
20
35
Ω/Wire
RL
600Ω
IDCMET
23mA
TIP
VTX
5
21
VTRO
RING
6
RSN
19
RT
600kΩ
RRX
ERX
300kΩ
FIGURE 1. OVERLOAD LEVEL (TWO-WIRE PORT)
1VRMS
0 < f < 100Hz
EL C
AT
TIP
300Ω
5
VT
2.16µF
300Ω
AR
VR
RING
6
LZT = VT/AT
VTX
21
RT
600kΩ
RSN
19
RRX
300kΩ
LZR = VR/AR
FIGURE 2. LONGITUDINAL IMPEDANCE
2