HC-5509B_03 Datasheet, PDF (2/9 Pages) Intersil Corporation – ITU CO/Loop Carrier SLIC

HC-5509B
Absolute Maximum Ratings (Note 1)
Relay Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to 15V
Maximum Supply Voltages
(V_B+) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to 7V
(V_B+)-(V_B-) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .75V
Operating Conditions
Operating Temperature Range
HC-5509B-5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0^oC to 75^oC
Relay Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5V to 12V
Positive Power Supply (V_B+) . . . . . . . . . . . . . . . . . . . . . . . . 5V ±5%
Negative Power Supply (V_B-) . . . . . . . . . . . . . . . . . . . . -42V to -58V
Loop Resistance (R_L) . . . . . . . . . . . . . . . . .200Ω to 1750Ω (Note 2)
Thermal Information
Thermal Resistance (Typical, Note 3)
θ_JA (^oC/W) θ_JC (^oC/W)
SOIC Package . . . . . . . . . . . . . . . . . . .
72
N/A
Maximum Junction Temperature Plastic . . . . . . . . . . . . . . . . .150^oC
Storage Temperature Range . . . . . . . . . . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300^oC
(For SMD; SOIC - Lead Tips Only)
Die Characteristics
Transistor Count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 224
Diode Count. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
Die Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 174 x 120
Substrate Potential . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connected
Process . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Bipolar-DI
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Absolute maximum ratings are limiting values, applied individually, beyond which the serviceability of the circuit may be impaired. Functional
operability under any of these conditions is not necessarily implied.
2. May Be Extended to 1900Ω With Application Circuit.
3. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at T_A = 25^oC, Min-Max Parameters are Over Operating
Temperature Range, V_B- = -48V, V_B+ = 5V, AG = DG = BG = 0V. All AC Parameters are specified at 600Ω
2-Wire Terminating Impedance
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNITS
AC TRANSMISSION PARAMETERS
RX Input Impedance
TX Output Impedance
300Hz to 3.4kHz (Note 4)
300Hz to 3.4kHz (Note 4)
-
100
-
kΩ
-
-
20
Ω
4-Wire Input Overload Level
300Hz to 3.4kHz R_L = 1200Ω ,
600Ω Reference
1.5
-
-
V_PEAK
2-Wire Return Loss
SRL LO
Matched for 600Ω (Note 4)
26
35
-
dB
ERL
30
40
-
dB
SRL HI
30
40
-
dB
2-Wire Longitudinal to Metallic Balance
Off Hook
Per ANSI/IEEE STD 455-1976 (Note 4) 300Hz to 58
63
-
dB
3400Hz
4-Wire Longitudinal Balance
Off Hook
300Hz to 3400Hz (Note 4)
50
55
-
dB
Low Frequency Longitudinal Balance
Longitudinal Current Capability
Insertion Loss
2-Wire/4-Wire
R.E.A. Test Circuit
I_LINE = 40mA, T_A = 25^oC (Note 4)
I_LINE = 40mA, T_A = 25^oC (Note 4)
0dBm at 1kHz, Referenced 600Ω
-
-
-67
dBmp
-
-
23
dBrnC
-
-
30
mA_RMS
-
±0.05 ±0.2
dB
4-Wire/2-Wire
-
±0.05 ±0.2
dB
4-Wire/4-Wire
-
-
±0.2
dB
Frequency Response
300Hz to 3400Hz (Note 4) Referenced to
-
Absolute Level at 1kHz, 0dBm Referenced 600Ω
±0.02 ±0.05
dB
Level Linearity
2-Wire to 4-Wire and 4-Wire to 2-Wire
Referenced to -10dBm (Note 4)
+3 to -40dBm
-
-
±0.05
dB
-40 to -50dBm
-
-
±0.1
dB
-50 to -55dBm
-
-
±0.3
dB
2