HC-5509B_03 Datasheet, PDF (1/9 Pages) Intersil Corporation – ITU CO/Loop Carrier SLIC

®
REC^{DOOaMBtaMSOSENLhEeDHTeECEtD5P5R1RE2OP0DLUACCTEMENT}
August 2003
HC-5509B
FN2799.8
ITU CO/Loop Carrier SLIC
The HC-5509B telephone Subscriber Line Interface Circuit
integrates most of the BORSCHT functions on a monolithic
IC. The device is manufactured in a Dielectric Isolation (DI)
process and is designed for use as a high voltage interface
between the traditional telephone subscriber pair (Tip and
Ring) and the low voltage filtering and coding/decoding
functions of the line card. Together with a secondary
protection diode bridge and “feed” resistors, the device will
withstand 1000V lightning induced surges, in plastic
packages. The SLIC also maintains specified transmission
performance in the presence of externally induced
longitudinal currents. The BORSCHT functions that the SLIC
provides are:
Battery Feed with Subscriber Loop Current Limiting
• Overvoltage Protection
• Ring Relay Driver
• Supervisory Signaling Functions
• Hybrid Functions (with External Op Amp)
• Test (or Battery Reversal) Relay Driver
In addition, the SLIC provides selective denial of power to
subscriber loops, a programmable subscriber loop current
limit from 20mA to 60mA, a thermal shutdown with an alarm
output and line fault protection. Switch hook detection, ring
trip detection and ground key detection functions are also
incorporated in the SLIC device.
The HC-5509B SLIC is ideally suited for line card designs in
PBX and CO systems, replacing traditional transformer
solutions.
Part Number Information
PART
NUMBER
HC9P5509B-5
TEMP.
RANGE (^oC)
PACKAGE
0 to 75 28 Ld SOIC
PKG. DWG.
#
M28.3
Features
• DI Monolithic High Voltage Process
• Compatible with Worldwide PBX and CO Performance
Requirements
• Controlled Supply of Battery Feed Current with
Programmable Current Limit
• Operates with 5V Positive Supply (V_B+)
• Internal Ring Relay Driver and a Utility Relay Driver
• High Impedance Mode for Subscriber Loop
• High Temperature Alarm Output
• Low Power Consumption During Standby Functions
• Switch Hook, Ground Key, and Ring Trip Detection
• Selective Power Denial to Subscriber
• Voice Path Active During Power Denial
• On-Chip Op Amp for 2-Wire Impedance Matching
Applications
• Solid State Line Interface Circuit for PBX or Central Office
Systems, Digital Loop Carrier Systems
• Hotel/Motel Switching Systems
• Direct Inward Dialing (DID) Trunks
• Voice Messaging PBXs
• High Voltage 2-Wire/4-Wire, 4-Wire/2-Wire Hybrid
• Related Literature
- AN9607, Impedance Matching Design Equations
- AN9628, AC Voltage Gain
- AN9608, Implementing Pulse Metering
- AN549, The HC-5502S/4X Telephone Subscriber Line
Interface Circuits (SLIC)
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2003. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.