X40010 Datasheet, PDF (15/24 Pages) Xicor Inc. – Dual Voltage Monitor with Integrated CPU Supervisor

X40010, X40011, X40014, X40015
D.C. OPERATING CHARACTERISTICS (Continued)
(Over the recommended operating conditions unless otherwise specified)
Symbol
Parameter
Second Supply Monitor
I_V2
V2MON Current
V_TRIP2(5) V2MON Trip Point Voltage Range
Min. Typ.⁽⁴⁾ Max.
15
1.7
4.75
0.9
3.5
2.85
2.9
2.95
2.55
2.6
2.65
1.65
1.7
1.75
1.25
1.3
1.35
0.95
1.0
1.05
Unit
Test Conditions
µA
V X40010/11
V X40014/15
V X40010/11-A
V X40010/11-B
V X40010/11-C
V X40014/15-A&B
V X40014/15-C
Notes: (1) The device enters the Active state after any start, and remains active until: 9 clock cycles later if the Device Select Bits in the Slave
Address Byte are incorrect; 200ns after a stop ending a read operation; or t_WC after a stop ending a write operation.
(2) The device goes into Standby: 200ns after any stop, except those that initiate a high voltage write cycle; t_WC after a stop that initiates a
high voltage cycle; or 9 clock cycles after any start that is not followed by the correct Device Select Bits in the Slave Address Byte.
(3) V_IL Min. and V_IH Max. are for reference only and are not tested.
(4) At 25°C, V_CC = 5V.
(5) See Ordering Information for standard programming levels. For custom programmed levels, contact factory.
(6) Based on characterization data.
EQUIVALENT INPUT CIRCUIT FOR VxMON (x = 1, 2)
R
∆V
V_ref
VxMON
+
C
V_REF
–
Output Pin
t_RPDX = 5µs worst case
∆V = 100mV
CAPACITANCE
Symbol
C_OUT(1)
C_IN(1)
Parameter
Output Capacitance (SDA, RESET, RESET, V2FAIL,
WDO)
Input Capacitance (SCL)
Note: (1) This parameter is not 100% tested.
Max.
8
6
Unit
pF
pF
Test Conditions
V_OUT = 0V
V_IN = 0V
15
FN8111.0
March 28, 2005