SMFLHP283R3S_16 Datasheet, PDF (15/15 Pages) Interpoint Corporation Company – SMFLHP Single and Dual DC-DC Converters

Crane Aerospace & Electronics Power Solutions
SMFLHP Single and Dual DC-DC Converters
28 Volt input – 100 Watt
Table is for reference only. See individual Series' datasheets for specific screening.
enVironmenTal Screening Space dc-dc conVerTerS proToType,
claSS h and claSS K, rha ¹ p, l and r
non-Qml ²
Qml ³
TeST performed
non-destruct wire bond pull, Method 2023
proToType
/oo ⁴
/hp
n⁵
claSS h
/hl
n⁵
/hr
n⁵
claSS K
/Kp /Kl /Kr
n
n
n
pre-cap inspection, Method 2017, 2032
n
n
n
n
n
n
n
temperature cycle (10 times) (Qual 100 times)
Method 1010, Cond. C, -65°C to +150°C, ambient
n
n
n
n
n
n
n
constant acceleration
Method 2001, 3000 g (Qual 5000 g)
n
n
n
n
n
n
n
pind, test Method 2020, cond. a
n⁵
n⁵
n⁵
n
n
n
pre burn-in test, group a, subgroups 1 and 4
n
n⁵
n⁵
n⁵
n
n
n
burn-in Method 1015, +125°c case, typical ⁶
96 hours
n
160 hours
n
n
n
2 x 160 hours (includes mid-BI test)
n
n
n
Final electrical test, MiL-prF-38534, group a,
Subgroups 1 and 4: +25°C case
n
Subgroups 1 through 6, -55°C, +25°C, +125°C case
n
n
n
n
n
n
Hermeticity test, Method 1014
Gross Leak, Cond. B₂, Kr85
Gross Leak, Cond. C₁, fluorocarbon
Fine Leak, Cond. B₁, Kr85
Fine Leak, Cond. A₂, helium
radiography, Method 2012
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
post radiography electrical test, +25°c case
n⁵
n⁵
n⁵
Final visual inspection, Method 2009
n
n
n
n
n
n
n
rHa p: 30 krad(si) total dose ^{1, 7, 8}
n
n
rHa L: 50 krad(si) total dose ^{1, 7, 8}
n
n
rHa r: 100 krad(si) total dose ^{1, 7, 8}
n
n
see, Let 86 MeV cm²/mg ^{1, 9}
n
n
n
n
n
n
Test methods are referenced to MIL-STD-883 as determined by MIL-PRF-38534.
Notes
1. Our Redmond facility has a DLA approved RHA plan for Interpoint power
products. Our SMD products with RHA “P”, “L” or “R” code meet DLA
requirements.
2. Non-QML prototype products may not meet all of the requirements of
MIL-PRF-38534.
3. All processes are QML qualified and performed by certified operators.
4. “O” in the RHA designator position in Interpoint model numbers indicates DLA
RHA “-” defined as no RHA.
5. Not required by DLA but performed to assure product quality.
6. Burn-in temperature designed to bring the case temperature to +125°C minimum.
Burn-in is a powered test.
7. High dose rate test.
8. Low dose rate test.
9. No destructive events or SEL.
table 4: enVirOnmental Scre^Teanbilneg^ 1S0p^: a^EcnevD^irc^o-ⁿD^mc^enc^taOlnVSecrrteeernSinp^graOntdOtRy^Hpe^{A, LcelvaeSlSs}h anD claSS K, rha p, l anD r
SMFLHP Single and Dual, SMFLHP Rev AC - 2016.02.17. This revision supersedes all previous releases. All technical information is
believed to be accurate, but no responsibility is assumed for errors or omissions. Crane Electronics, Inc. reserves the right to make
changes in products or specifications without notice. Interpoint is a registered trademark of Crane Co. and SMFLHP Series is a trademark of
Crane Electronics, Inc. Copyright © 1999 - 2016 Crane Electronics, Inc. All rights reserved. www.craneae.com/interpoint
Page 15 of 15