DG33FB Datasheet, PDF (69/88 Pages) Intel Corporation – Technical Product Specification

4 Error Messages and Beep Codes
What This Chapter Contains
4.1 Speaker ......................................................................................... 69
4.2 BIOS Beep Codes ............................................................................ 69
4.3 BIOS Error Messages ....................................................................... 69
4.4 Port 80h POST Codes ....................................................................... 70
4.1 Speaker
The board-mounted speaker provides audible error code (beep code) information
during POST.
For information about
The location of the onboard speaker
Refer to
Figure 1, page 12
4.2 BIOS Beep Codes
Whenever a recoverable error occurs during POST, the BIOS displays an error
message describing the problem (see Table 34).
Table 34. Beep Codes
Type
Pattern
Memory error
Three long beeps
Thermal warning
Four alternating beeps:
High tone, low tone, high tone, low tone
Frequency
1280 Hz
High tone: 2000 Hz
Low tone: 1600 Hz
4.3 BIOS Error Messages
Table 35 lists the error messages and provides a brief description of each.
Table 35. BIOS Error Messages
Error Message
Explanation
CMOS Battery Low
The battery may be losing power. Replace the battery soon.
CMOS Checksum Bad
Memory Size Decreased
The CMOS checksum is incorrect. CMOS memory may have been
corrupted. Run Setup to reset values.
Memory size has decreased since the last boot. If no memory
was removed, then memory may be bad.
No Boot Device Available
System did not find a device to boot.
69