DG33FB Datasheet, PDF (34/88 Pages) Intel Corporation – Technical Product Specification

Intel Desktop Board DG33FB Technical Product Specification
1.13.2.2 Fan Headers
The function/operation of the fan headers is as follows:
• The fans are on when the board is in the S0 state.
• The fans are off when the board is off or in the S3, S4, or S5 state.
• The processor and Auxiliary fan headers are wired to a fan tachometer input and
the Front and Rear fan headers share the tachometer input of the hardware
monitoring and fan control device. All fan headers support closed-loop fan control
that can adjust the fan speed or switch the fan on or off as needed.
• All fan headers have a +12 V DC connection.
For information about
The locations of the fan headers and thermal sensors
The signal names of the processor fan header
The signal names of the chassis fan headers
Refer to
Figure 6, page 29
Table 15, page 44
Table 14, page 44
1.13.2.3 LAN Wake Capabilities
CAUTION
For LAN wake capabilities, the +5 V standby line from the power supply must be
capable of providing adequate +5 V standby current. Failure to provide adequate
standby current when implementing LAN wake capabilities can damage the power
supply.
LAN wake capabilities enable remote wake-up of the computer through a network.
The LAN subsystem PCI bus network adapter monitors network traffic at the Media
Independent Interface. Upon detecting a Magic Packet* frame, the LAN subsystem
asserts a wake-up signal that powers up the computer. Depending on the LAN
implementation, the board supports LAN wake capabilities with ACPI in the following
ways:
• The PCI Express WAKE# signal
• The PCI bus PME# signal for PCI 2.3 compliant LAN designs
• The onboard LAN subsystem
34