DG33FB Datasheet, PDF (15/88 Pages) Intel Corporation – Technical Product Specification

Product Description
1.2 Legacy Considerations
This board differs from other Intel^® Desktop Board products, with specific changes
including (but not limited to) the following:
• No parallel port
• The location of the floppy drive connector has moved
• No serial port on the back panel
• The serial port header is located between the memory sockets and may require a
specialized chassis or cabling solution to use
1.3 Online Support
To find information about…
Intel Desktop Board DG33FB
Desktop Board Support
Available configurations for the
Desktop Board DG33FB
Supported processors
Chipset information
BIOS and driver updates
Tested Memory
Visit this World Wide Web site:
http://www.intel.com/products/motherboard/DG33FB/index.htm
http://support.intel.com/support/motherboards/desktop
http://www.intel.com/products/motherboard/DG33FB/index.htm
http://www.intel.com/go/findcpu
http://www.intel.com/products/desktop/chipsets/index.htm
http://downloadcenter.intel.com
http://support.intel.com/support/motherboards/desktop/sb/CS-
025414.htm
1.4 Processor
The board is designed to support the following processors:
• Intel Core 2 Quad processor in an LGA775 socket with a 1066 MHz system bus
• Intel Core 2 Duo processor in an LGA775 socket with a 1066 or 800 MHz
system bus
• Intel Pentium Dual-Core processor in an LGA775 socket with an 800 MHz
system bus
• Intel Celeron processor in an LGA775 socket with an 800 MHz system bus
Other processors may be supported in the future. This board is designed to support
processors with a maximum wattage of 95 W. The processors listed above are only
supported when falling within the wattage requirements of the DG33FB board. See
the Intel web site listed below for the most up-to-date list of supported processors.
For information about…
Supported processors
Refer to:
http://www.intel.com/go/findcpu
CAUTION
# ^{INTEGRATOR’S NOTE}
Use only ATX12V-compliant power supplies.
For information about
Power supply connectors
Refer to
Section 2.2.2.4, page 46
15