80C196MH Datasheet, PDF (21/41 Pages) Intel Corporation – 8XC196MH INDUSTRIAL MOTOR CONTROL CHMOS MICROCONTROLLER

®
8XC196MH INDUSTRIAL MOTOR CONTROL CHMOS MICROCONTROLLER
Table 8. DC Characteristics over Specified Operating Conditions (Continued)
Symbol
Parameter
Min
Typ (4) Max Units Test Conditions
I_IL1
Input Low Current (P5.4
and P2.6 during reset) (2)
– 10
mA V_IN = 0.8 V
I_IL2
Input Low Current (ports 3,
4, and 5, except P5.4)
– 300
µA V_IN = 0.8 V
I_IL3
Input Low Current (port 1)
I_OH
Output High Current (P5.4
– 0.2
and P2.6 during reset) (3)
– 300
µA V_IN = 0.3 V_CC
mA 0.7 V_CC
I_OH1
Output High Current
–6
(P6.5:0 during reset)
– 40
µA 0.7 V_CC
I_CC
V_CC Supply Current
I_REF
A/D Reference Supply
Current
50
70
mA XTAL1 = 16 MHz
V_CC = 5.5 V
V_PP = 5.5 V
V_REF = 5.5 V
2
5
mA
I_IDLE
Idle Mode Current
I_PD
Powerdown Mode Current
(4)
15
30
mA
5
50
µA
R_RST
Reset Pull-up Resistor
6
65
kΩ
C_S
Pin Capacitance (any pin
to V_SS)
10
pF F_TEST = 1.0 MHz
NOTES:
1. Standard input pins include XTAL1, EA#, and Ports 1 and 2 when configured as inputs.
2. Maximum current that an external device must sink to ensure test mode entry.
3. Violating these specifications during reset may cause the device to enter test modes.
4. Typical values are based on a limited number of samples and are not guaranteed. Operating conditions
for typical values are room temperature and V_REF = V_CC = 5.5 V.
5. Testing is performed down to 8 MHz, although the device is static by design and will typically operate
below 1 Hz.
6. All voltages are referenced relative to V_SS. When used, V_SS refers to the device pin.
7. Table 9 lists the total current limits during normal (non-transient conditions). The total current listed is the
sum of the pins listed for each specification value.
21