80C196MH Datasheet, PDF (20/41 Pages) Intel Corporation – 8XC196MH INDUSTRIAL MOTOR CONTROL CHMOS MICROCONTROLLER

8XC196MH INDUSTRIAL MOTOR CONTROL CHMOS MICROCONTROLLER
®
DC CHARACTERISTICS
Table 8. DC Characteristics over Specified Operating Conditions
Symbol
Parameter
Min
Typ (4) Max Units Test Conditions
V_IL
Input Low Voltage
(standard inputs (1))
– 0.5
0.3 V_CC
V
V_IL1
Input Low Voltage
– 0.5
(RESET#, ports 3, 4, and
5)
0.8
V
V_IH
Input High Voltage
0.7 V_CC
(standard inputs (1))
V_CC + 0.5 V
V_IH1
Input High Voltage
0.2 V_CC + 1.0
(RESET#, ports 3, 4, and
5)
V_CC + 0.5 V
V_OL
Output Low Voltage
(RESET#, ports 1, 2, 5,
P6.6, P6.7, and XTAL2)
V_OL1
Output Low Voltage (ports
3, 4)
0.3
0.45
1.5
1.0
V I_OL = 200 µA
V _{IOL = 3.2 mA}
V _{IOL = 7.0 mA}
V I_OL = 7 mA
V_OL2
Output Low Voltage
(P6.5:0)
0.45
V I_OL = 10 mA
V_OH
Output High Voltage
V_CC – 0.3
(output pins and I/O
V_CC – 0.7
configured as push/pull
V_CC – 1.5
outputs)
V I_OH = – 200 µA
V I_OH = – 3.2 mA
V _{IOH = – 7.0 mA}
V_TH+ – V_TH– Hysteresis voltage width
0.2
V
on RESET# pin
I_LI
Input Leakage Current
(standard inputs (1))
± 10
µA V_SS < V_IN < V_CC – 0.3V
I_LI1
Input Leakage Current
(port 0 – A/D inputs)
±3
µA V_SS < V_IN < V_REF
I_IH
Input High Current (NMI)
I_IL
Input Low Current (port 2,
except P2.6)
300
− 70
µA V_IN = 0.7 V_CC
µA V_IN = 0.3 V_CC
NOTES:
1. Standard input pins include XTAL1, EA#, and Ports 1 and 2 when configured as inputs.
2. Maximum current that an external device must sink to ensure test mode entry.
3. Violating these specifications during reset may cause the device to enter test modes.
4. Typical values are based on a limited number of samples and are not guaranteed. Operating conditions
for typical values are room temperature and V_REF = V_CC = 5.5 V.
5. Testing is performed down to 8 MHz, although the device is static by design and will typically operate
below 1 Hz.
6. All voltages are referenced relative to V_SS. When used, V_SS refers to the device pin.
7. Table 9 lists the total current limits during normal (non-transient conditions). The total current listed is the
sum of the pins listed for each specification value.
20