|
Q67060-S6136 Datasheet, PDF (5/18 Pages) Infineon Technologies AG – Addendum for PCN-Datasheet 2004-018-A | |||
|
◁ |
PCN 2004-018-A: BTS 5440G
Maximum Ratings at Tj=25°C, unless otherwise specified
Parameter
Symbol Value Unit
Supply voltage (overvoltage protection see page 6)
Supply voltage for full short circuit protection;Tj = -40...150°C
Maximum voltage across DMOS
Load dump protection3) VLoadDump4) = VA + VS; VA = 13,5 V
In = low or high; td = 400 ms; RI4) = 2 â¦
RL = 2.25 â¦
RL = 6.8 â¦
Load current (Short - circuit current, see page 7)
Operating temperature range
Storage temperature range
Vbb
281) V
Vbb(SC)
282)
VON
52
VLoaddump
40
53
IL
IL(lim)5) A
Tj
-40...+150 °C
Tstg
-55...+150
Dynamical temperature rise at switching
dT
60
K
Power dissipation6) (DC), all channels active TA = 85 °C Ptot
Maximal switchable inductance, single pulse
ZL(s)
Vbb=12V, Tjstart=150°C;
(see diagrams on page 12)
IL = 6 A, EAS = 0.319 J, RL = 0 â¦,
one channel:
IL = 12 A, EAS = 0.679 J, RL = 0 â¦, two parallel channels:
Electrostatic discharge voltage
IN: VESD
(Human Body Model)
IS:
1,6 W
mH
9.8
5.2
1,0 kV
2,0
according to ANSI EOS/ESD - S5.1 - 1993 , ESD STM5.1 - 1998 OUT:
4,0
Continuous input voltage
Voltage at current limit adjustment pin
Current through current limit adjustment pin
Current through input pin (DC)
Current through sense pin (DC) (see page 11)
VIN
VCLA
I CLA
IIN
IIS
-10...16 V
-10...16
±5.0 mA
±5.0
-5...+10
118...28 V for 100 hours
2only single pulse, RL = 200 m⦠; L = 8 µH ; R and L are describing the complete circuit impedance including
line, contact and generator impedances.
3Supply voltage higher than Vbb(AZ) require an external current limit for the GND (150⦠resistor) and sense pin.
4RI = internal resistance of the load dump test pulse generator.
5Current limit is a protection function. Operation in current limitation is considered as "outside" normal operating
range. Protection functions are not designed for continuous repetitive operation.
6Device on 50mm*50mm*1.5mm epoxy PCB FR4 with 6 cm2 (one layer, 70µm thick) copper area for Vbb
connection. PCB is vertical without blown air.
Page 4
2004-Mar-08
|
▷ |