1EDI10I12MH Datasheet, PDF (5/18 Pages) Infineon Technologies AG – Single channel IGBT gate driver IC with clamp in wide body package

EiceDRIVER^™ 1EDI Compact
Single channel IGBT gate driver IC with clamp in wide body package
Pin Configuration and Functionality
Due to internal filtering a minimum pulse width is defined to ensure robustness against noise at IN-. An internal
weak pull-up-resistor favors off-state.
GND1
Ground connection of input circuit.
GND2 Reference Ground
Reference ground of the output driving circuit.
VCC2
Positive power supply pin of output driving circuit. A proper blocking capacitor has to be placed close to this
supply pin.
OUT Driver Output
Combined source and sink output pin to external IGBT. The output voltage will be switched between VCC2 and
GND2 and is controlled by IN+ and IN-. In case of an UVLO event this output will be switched off and an active
shut down keeps the output voltage at a low level.
CLAMP Active Miller Clamp
Connect gate of external IGBT directly to this pin. As soon as the gate voltage has dropped below 2 V referred to
GND2 during turn off state the CLAMP function ties its output to GND2 to avoid parasitic turn on of the
connected IGBT.
Datasheet
5
Rev. 2.0
2016-07-05