1EDI10I12MH Datasheet, PDF (4/18 Pages) Infineon Technologies AG – Single channel IGBT gate driver IC with clamp in wide body package

EiceDRIVER^™ 1EDI Compact
Single channel IGBT gate driver IC with clamp in wide body package
Pin Configuration and Functionality
2
Pin Configuration and Functionality
2.1
Pin Configuration
Table 1
Pin No.
1
2
3
4
5
6
7
8
Pin Configuration
Name
VCC1
IN+
IN-
GND1
GND2
VCC2
OUT
CLAMP
Function
Positive logic supply
Non-inverted driver input (active high)
Inverted driver input (active low)
Logic ground
Power ground
Positive power supply voltage
Driver output
Active Miller clamp
1
VCC1
2
IN+
3
IN-
4
GND1
Figure 2 PG-DSO-8-59 (top view)
CLAMP
8
OUT
7
VCC2
6
GND2
5
2.2
Pin Functionality
VCC1
Logic input supply voltage of 3.3 V up to 15 V wide operating range.
IN+ Non Inverting Driver Input
IN+ non-inverted control signal for driver output if IN- is set to low. (Output sourcing active at IN+ = high and IN-
= low)
Due to internal filtering a minimum pulse width is defined to ensure robustness against noise at IN+. An internal
weak pull-down-resistor favors off-state.
IN- Inverting Driver Input
IN- inverted control signal for driver output if IN+ is set to high. (Output sourcing active at IN- = low and IN
+ = high)
Datasheet
4
Rev. 2.0
2016-07-05