V23832-T2131-M101 Datasheet, PDF (21/30 Pages) Infineon Technologies AG – PAROLI 2 Tx AC, 1.6 Gbit/s

V23832-T2131-M101
V23832-R121-M101
Technical Data
Receiver Electrical Characteristics
Parameter
Symbol
Values
Unit
min.
typ.
max.
Supply Current¹⁾
I_CC
Power Consumption¹⁾
P
280
340
mA
0.9
1.2
W
LVDS Output Low Voltage^{2), 3)}
LVDS Output High Voltage^{2), 3)}
LVDS Output Differential
Voltage^{2), 3), 4), 5)}
V_LVDSOL
V_LVDSOH
|V_OD|
925
250
mV
1475
mV
400
mV
LVDS Output Offset Voltage^{2), 3), 6)} V_OS
1125
LVDS Rise/Fall Time⁷⁾
t_R-LVDS,
t_F-LVDS
LVCMOS Output Voltage Low V_LVCMOSOL
LVCMOS Output Voltage High V_LVCMOSOH 2500
LVCMOS Input Current
High/Low
I_LVCMOSI –100
1275
mV
230
ps
400
mV
mV
100
µA
LVCMOS Output Current High⁸⁾
LVCMOS Output Current Low⁹⁾
Total Jitter ^{10), 11), 12), 13), 14)}
I_LVCMOSOH
I_LVCMOSOL
TJ
0.5
mA
4.0
mA
0.33
UI
Deterministic Jitter^{10), 13), 15)}
DJ
0.12
UI
Channel-to-channel skew¹⁶⁾
t_CSK
100
ps
1) _{Typical value is measured at Tcase = 45°C and 3.3 V, maximum value is measured at Tcase = 80°C and 3.6 V.}
2) _{Output level diagram: see Figure 8 on Page 16.}
3) _{LVDS output must be terminated differentially with Rt.}
4) _{|VOD| = |(output voltage of non-inverted output minus output voltage of inverted output)|.}
5) _{Unused channels must be terminated by 50 Ω.}
6) _{VOS = 1/2 (output voltage of inverted output + output voltage of non-inverted output).}
7) _{Measured between 20% and 80% level with a maximum capacitive load of 3 pF.}
8) _{Source current.}
9) _{Sink current.}
10) _{With no optical input jitter.}
11) _{Measured with an optical input power of 3 dB above minimum receiver sensitivity.}
12) _{Unused channels can be terminated by 50 Ω or left open.}
13) _{UI (Unit Interval) is equal to the length of one bit. For example, 2.72 Gbit/s corresponds to 368 ps.}
14) _{The Total Jitter (TJ) is the sum from Random Jitter (RJ) and Deterministic Jitter (DJ) according to:}
TJ = RJ (14 Sigma value) + DJ.
The TJ is specified at a BER of 10^–12 from TP3 to TP4 according to IEEE 802.3, sec. 38.5.
The RJ is measured at the 50% level of the optical signal as the mean of the rising and falling edge RJ
measurement value.
Data Sheet
21
2003-11-19