V23832-T2131-M101 Datasheet, PDF (19/30 Pages) Infineon Technologies AG – PAROLI 2 Tx AC, 1.6 Gbit/s

V23832-T2131-M101
V23832-R121-M101
Technical Data
Transmitter Electro-Optical Characteristics
Parameter
Symbol
Values
Unit
Optical Rise Time¹⁾
Optical Fall Time¹⁾
Total Jitter^{2), 3)}
Deterministic Jitter^{3), 4)}
Channel-to-channel skew⁵⁾
Launched Average Power⁶⁾
Launched Power Shutdown
Center Wavelength⁷⁾
Spectral Width (rms)⁸⁾
Relative Intensity Noise⁹⁾
t_R
t_F
TJ
DJ
t_CSK
P_AVG
P_SD
λ_C
∆λ
RIN
min.
–8.0
830
typ.
–5.0
850
0.35
max.
200
200
0.284
0.1
100
–3.0
–30.0
860
0.65
–117
ps
ps
UI
UI
ps
dBm
dBm
nm
nm
dB/Hz
Extinction Ratio (dynamic)
ER
6.0
dB
Optical Modulation
Amplitude^{10), 11)}
Eye mask compliance
OMA
0.19 ¹²⁾
0.46¹³⁾
to be defined¹⁴⁾
mW
Electro-optical parameters valid for each channel and measured at the highest specified data rate.
All optical parameters are measured with a 62.5 µm multimode fiber.
1) _{20% - 80% level, non filtered values.}
2) _{The Total Jitter (TJ) is composed of Random Jitter (RJ) and Deterministic Jitter (DJ) according to:}
TJ = RJ (14 Sigma value) + DJ.
The TJ is specified at a BER of 10^–12 from TP1 to TP2 according to IEEE 802.3, sec. 38.5.
The RJ is measured at the 50% level of the optical signal as the mean of the rising and falling edge
measurement value.
3) _{UI (Unit Interval) is equal to the length of one bit. For example, 2.72 Gbit/s corresponds to 368 ps.}
4) _{The DJ consists of Duty Cycle Distortion and Data Dependent Jitter and is measured according to IEEE 802.3}
using a K28.5 pattern.
5) _{With input channel-to-channel skew 0 ps and a maximum data channel-to-channel average deviation and}
swing deviation of 5%.
6) _{The specified output power is compliant with IEC 60825-1, Amendment 2, Class 1M Accessible Emission}
Limits (AEL).
7) _{Wavelength is measured according to IEEE 802.3, sec. 38.6.1.}
8) _{Spectral width is measured according to IEEE 802.3, sec. 38.6.1.}
9) _{RIN is measured according to IEEE 802.3, sec. 38.6.4.}
10) _{Peak to peak values.}
11) _{OMA is defined as the difference of the optical high state (’1’) and the optical low state (’0’):}
OMA = P_opt(’1’) – P_opt(’0’).
12) _{Corresponds to a minimum extinction ratio of 6 dB.}
13) _{Corresponds to a typical extinction ratio of 8 dB.}
14) _{GBE mask (IEEE 802.3, sec. 38.6.5.) adopted for data rate available.}
Data Sheet
19
2003-11-19